Husqvarna HVA125BX, HVA125BVX, 35874122, 125BX, 125BV Owner’s Manual

FR Manuel d'utUisation, pp. 23-44 I 2SEx_sERIES
EN Operator's manual, pp, 2-22 .125B Q
ES Manual de instrucciones, pp. 45-66
EN FR ES
CONTENTS
Contents
Fuel handling .................... 11
Starting and stopping ............ 12
Using the blower ................. 13
Maintenance .................... 18
Technical data ................... 19
Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine re-
pair establishment or individual
WARNING
Theengine exhaust from this product
containschemicalsknown to theState
ofCaliforniatocausecancer,birth
defectsorotherreproductiveharm.
Note the following before
starting:
Husqvama AB has a policy of continuous
product development and therefore reserves the right to modify the design and appearance of products without prior
noede. Long-term exposure to noise can result in permanent hearing impairment.
Always use approved hearing protection. This operator's manual describes in detaJ+
how to use and service the blower and how to carry out regular maintenance. It
also descdbes which measures should be taken to achieve maximum safety while operating the blower, how the safety de- vices work and how they should be ser-
viced.
Note[ The section of the manual that deals
with safety, must be read and understood by all persons who come in contact with
the blower. This operator's manual has been wdnen
for those who need guidance when it comes to fault tracing, thorough servicing and carrying out corrective maintenance of
the blower. There are warning symbols on the blower.
Should any of the warning symbols on the blower become disfigured or worn, new ones
should be ordered and fitted to the blower as soon as possible. Note that some of the warning symbols may be molded in certdln
components of the blower.
The blower is used for blowing away leaves and other debris on the ground. When op-
erating the blower, the operator must stand with both feet firmly on the ground.
The Emissions Compliance Period referred to on the Emissions Compliance label indi-
cates the number of operating hours for which the engine has been shown to meet Federal emissions requirements.
Category C 50 hours, B 125 hours, and A 300 hours.
For reference, please fill out the following information that will be needed for future
servicing of your blower:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING: Under no circum-
stances may the design of the
machine be modified without the permission of the manufacturer.
Always use genuine accessories.
Non-authorized modifications
and/or accessories can result in serious personal injury or the
death of the operator or others. Your warranty may not cover
damage or liabiIRy caused by the use of non-authorized accesso-
ries or replacement parts.
For customer assistance, calI:
1-800-487-5951
Contact us at our website:
www.husqvarna.com
English-2545154658 Rev. 5 7/15/08
KEY TO SYMBOLS
o_ _ el Descrtpt{on LocationSymbol Descrlptien Locatio_ ;yml _ _"_.
lllmaythr°wohi tsatI I
carried out after
nected tile spark plug sedous eye damage
II_ f II high veJocity that can { I
ricochet and hit the op- × ×
_ eratoL This may causethe engine and discon-
_ Cleaning at regulal X _ The btower oparatol
I_ I i {than50feet(15n_e- X X {_ Apploved plotective they should maiatahl a
_F'J Imask in dusty environ- I I II I _ I tels) from one another
i_ manual carefully and [
I Always wear approved, Other symbols/decals on the machine
intervals is required _ - no bystanders or
Applovedplotecfive II !tels) I I
goggles el visor must X Whenever sevelal
be WOrn. ope[ators are working
protection, and face X X ' _ least 50 feet (15 me- ments must be worn
WARNING! The blow- Choke X
er can he dangerous!
Care_easSc°_hs_P_°f_er X X
Read the operator's make sure that you X X Stop switch X
contents befole using the blowel
understand thecovel "._ _ _lf_t
that the inter is _._
position or that the X X
vaouum tub@ is mount-
lockedintheclosed
ed on the bloweE Never touch the impaIler un-
less the unit is off, the / impaller has stopped
moving and the spark plug is disoonneated
protective gloves X X refer to special certification requirements
i. must make sure that
( animals oome nealer
_'! ill the same work area,
!
for certain markets.
safe distance of atgoggles el visor, ear
x
545154658 Rev. 5 7/15/08 English-3
SAFETY INSTRUCTIONS
Personal safety equipment
Persons who use the blower shall wear the following safety equipment:
1. Approved ear protection.
2. Approved eye protection
3. Approved protective gloves.
4. Boots or work shoes with a non-slip sole.
5. Face mask when operating the blower in dusty environments.
Personal safety
The following instructions apply to persons operating the blower:
The operator shall have read and under-
stood the contents of this manual.
Do not wear loose clothing, scarves or
neckchains or let long hair hang loose, since these can be drawn into rotating
parts of the blower and cause injury.
Do not operate the blower while under
the influence of alcohol, drugs or when you are tired.
Do not allow minors to operate the
blower.
Always have a first aid kit nearby
Fuel safety
_ WARNING: The fuel used to run
the blower has the following
dangerous characteristics:
1. Volatile liquid: its vapor and
exhaust fumes are poisonous.
2, Direct contact can cause skin
irritation.
3. It is extremely flammable.
Special safety instructions apply to the type of fuel used for the blower. These instruc-
tions are specified under the Fuet handling section.
545154658 Rev. 5 7/15/08
Muffler
The muffler is designed to give the lowest possible noise level and to direct the en-
gine's exhaust fumes away from the opera- tor. Mufflers fitted with catalytic converters
are also designed to reduce harmful ex- haust components.
WARNING: The exhaust fumes
from the engine are hot and may contain sparks which can start a fire. Never start the machine indoors or near flammable material!
WARNING: Mufflers fitted with
catalytic converters become extreme- ly hot during use and after stopping. This also applies at idling speeds.
Contact can result in burns to the skin. Be aware of the risk of fire!
Safety equipment
WARNING: The blower must
never be used if any of the safety devices or guards are missing,
damaged or not in working order.
The blower is equipped with a number of safety devices and guards for the preven- tion of accidents. These are described in
the general description of the b_ower. The safety devices and guards also require
regular inspection and maintenance. These measures and the interval at which they
should be carried out are specified in the Maintenance section.
Safety while operating the
blower
Do not allow bystanders or animals to be in the work area, i.e 50 feet (15 meters)
from the operator.
The blower may throw objects at high velocity that can ricochet and hit the opera-
tor. This may cause serious eye damage.
Never point the blower nozzle toward people or animals.
Stop the engine before fitting or disman-
tling accessories or other components.
Never operate the blower if any of the guards are missing.
Never operate the blower in poorly venti- lated spaces where exhaust fumes might
otherwise be inhaled.
Stop the engine before refueling. Move
the unit at least 10 feet (3 meters) from fueling site before attempting to start.
The catalytic muffler is extremely hot while the blower is running and after it
has stopped. The same applies when the blower is running at idling speed. Be
aware of the danger of fire, especially while operating the blower near flam-
mable materials and/or where flammable
fumes are present
English-4
SAFETY INSTRUCTIONS
Be careful, particularly if _ett hand opera- tion is applied. Avoid any direct body con-
tact with inlet cover area. Keep jewelry,
loose clothing, or clothing with loosely hanging straps, ties, tassels, etc., away
from inlet cover area.
Do not operate the blower while standing
on a ladder or a stand.
Other safety measures
Operate the blower only at reasonable hours, i.e. not early in the morning or late
at night when people might be disturbed Comply with times listed in local ordi-
nances. Usual recommendations are 9:00 a.m to 5:00 p.m., Monday through Satur-
day.
Operate the blower at the lowest possible throttle setting to do the job.
Check the condition of the blower before
operation, especially the muffler, air intake and air filter.
Use a rake or a broom to loosen ground
debris before blowing
Under dusty conditions, slightly spray the work area with a hose.
Conserve water by using blowers instead
of hoses for many lawn and garden applications, including areas such as roof gutters, screens, patios and gardens etc.
Watch out for children, pets, open windows
or vehicles, and blow debris safely away.
Use the full nozzle extension so the air
stream can work close to the ground.
After using the blower, clean up and
dispose of debris in trash receptacles.
545154658 Rev. 5 7/15/08 English-5
The blower
DESCRIPTION
1. Shoulder strap (125BV x SERIES) 13. Fan impeller
2. Throttle trigger 14. Standard nozzle
3. STOPswitch 15. High ve{ocity nozzle
4. Variab{espeed control 16. BIowertube
5. Fan housing 17. Tube clamp bolt
6. Fuel cap 18. Tube clamp nut
7. Airfilter 19. Muffler
8. Choke 20. Ground wire
9. Primer bulb 21. Starter handle
10. Inlet cover 22. Starter device 11 Vacuum handle 23. Carburetor adjustment screws
(125Bx SERIESand 125BV x SERES) 24. 2-stroke engine oil
12. Cutters (125B x SEREESand 25. Operator's manual 125BVx SERIES)
54-5154658 Rev. 5 7/15/08 English-8
DESCRIPTION
Accessories (125Bx_sERIESand 125BVx_sERIES)
©
. @
21. Vacuum device with collection components consisting of items 22-26 below
22. Collection bag tube
23. Collection bag
24. Vacuum tube in two sections
25. Screw
26. Shoulder strap
545154658 Rev. 5 7/15/08 English-7
Loading...
+ 15 hidden pages