Setting Up Your Hughes Wi-Fi Booster With Your HT2000W Modem
Check the box contents
Before you begin, make sure the box has the contents shown inFigure 1.
Hughes Wi-Fi Booster
Power supply
LAN cable
Figure 1: Box contents
Con gure the Booster
For the initial setup, you must be near the HT2000W. To con gure the Hughes Wi-Fi Booster:
1.Plug the Booster into a power outlet using the provided power supply. Push the Power button ( ) on the back of the device to power it on.
2.Lay the Booster horizontally, as shown inFigure 2, so you can clearly see the LED on the bottom of it.Wait for the LED to turn red. This may take 1 minute. The LED will turn other colors before turning red.
1
150200199500J R01 AMD
Figure 2: Red LED – Booster is ready for con guration
3.Connect the Booster to the HT2000W with the provided LAN cable. Connect the cable from the yellow LAN port on the device to any LAN port on the HT2000W. See Figure 3.
|
|
2 |
Figure 3: Connect the Booster to the HT2000W |
|
|
|
|
|
1041400-0001 Revision B |
April 6, 2017 |