Huffy M732211 User Manual
1
05/06 ID# M732211
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-632 7921
Internet Address: http://www.huffysports.com
REQUIRED TOOLS
AND MATERIALS:
• (2 each) Wrenches
AND/OR
• Large & Small Adjustable
Wrenches
OPTIONAL TOOLS
AND MATERIALS:
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO
PROPERTY.
WARNING!
7/16" 1/2" 9/16" 3/4"
7/16" 1/2" 9/16" 3/4"
• 2 People
• Tape Measure
• Wood Board
(scrap)
• Sawhorse or
Support Table
• Tape
• Safety Glasses
• #3 Phillips
Screwdriver
• Needle-Nose Pliers
• Garden Hose or Sand
(360 lb.)
(360 lb.)
(163 kg)
(163 kg)
Write Model Number
From Box Here:
• Socket Wrenches and Sockets
(Deep-Well Sockets are
Recommended).
• Step Ladder 8ft. (2.4 m)
Portable System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
2
ID# M732211 05/06
Owner must ensure that all players know and follow these rules
for safe operation of the system.
WARNING
•
DO NOT HANG on the rim or any part of the system including
backboard, support braces or net.
•
During play, especially when performing dunk type activities,
keep player's face away from the backboard, rim and net.
Serious injury could occur if teeth/face come in contact with
backboard, rim or net.
•
Do not slide, climb, shake or play on base and/or pole.
•
After assembly is complete, fill system completely with water
or sand. Never leave system in an upright position without
filling base with weight, as system may tip over causing
injuries.
•
When adjusting height or moving system, keep hands and
fingers away from moving parts.
•
Do not allow children to move or adjust system.
•
During play, do not wear jewelry (rings, watches, necklaces,
etc.). Objects may entangle in net.
•
Surface beneath the base must be smooth and free of gravel or
other sharp objects. Punctures cause leakage and could cause
system to tip over.
•
Keep organic material away from pole base. Grass, litter, etc.
could cause corrosion and/or deterioration.
•
Check pole system for signs of corrosion (rust, pitting,
chipping) and repaint with exterior enamel paint. If rust has
penetrated through the steel anywhere, replace pole
immediately.
•
Check system before each use for proper ballast, loose
hardware, excessive wear and signs of corrosion and repair
before use.
•
Check system before each use for instability.
•
Do not use system during windy and/or severe weather
conditions; system may tip over. Place system in the storage
position and/or in an area protected from the wind and free
from personal property and/or overhead wires.
•
Never play on damaged equipment.
•
When moving system, use caution to keep mechanism from
shifting.
•
Keep pole top covered with cap at all times.
•
Do not allow water in tank to freeze. During sub-freezing
weather add 2 gallons of non-toxic antifreeze, sand or empty
tank completely and store. (Do not use salt.)
•
While moving system, do not allow anyone to stand or sit on
base or have added ballasting on base.
•
Do not leave system unsupervised or play on system when
wheels are engaged for moving.
•
Use Caution when moving system across uneven surfaces.
System may tip over.
•
Use extreme caution if placing system on sloped surface.
System may tip over more easily.
•
See instruction manual for proper installation and
maintenance.
Read and understand warnings listed
below before using this product.
Failure to follow these warnings may
result in serious injury and/or property
damage.
ID#: 556790 05/05
In the U.S.: 1-888-713-5488
In the U.S.: 1-800-558-5234
Canada: 1-800-284-8339
In the U.S.: 1-800-334-9111
In the U.S.: 1-800-772-5346
BEFORE YOU START!
To ensure optimal playability of backboard system, a
close tolerance fit between the elevator components
and hardware is required. Test-fit large bolts into large
holes of elevator tubes, backboard brackets, and
triangle plates. Carefully rock them in a circular
motion to ream out any excess paint from holes if
necessary.
Not all items pictured are included with every model.
05/06 ID# M732211
3
522730 06/05
MOVING
SYSTEM
HEIGHT ADJUSTMENT
TO RESET OR REPOSITION BACKBOARD:
1. Grasp handle firmly and pull down to raise rim PAST
highest position (above 10 feet).
2. While still holding handle firmly, CAREFULLY lower
rim to lowest position.
3. Raise to desired height by pulling down on handle.
READ BEFORE
OPERATING
ELEVATOR
SYSTEM
CAUTION!
DO NOT LET GO OF HANDLE
UNTIL THE RIM IS RESET AT
LOWEST POSTION OR
DESIRED HEIGHT.
FAILURE TO FOLLOW THIS
WARNING COULD RESULT
IN SERIOUS INJURY AND/OR
PROPERTY DAMAGE.
1. Adjust basketball
backboard height to
lowest position.
2. While holding pole,
rotate basketball
system forward until
wheels engage with
ground.
3. Move basketball
system to desired
location.
4. Carefully rotate
basketball system
upright.
5. Check system for
stability.
1.
3.
2.
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following
instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme
caution.
• Two (2) capable adults are recommended for this
operation.
• Check base regularly for leakage. Slow leaks could
cause system to tip over unexpectedly.
• Seat the pole sections properly (if applicable). Failure
to do so could allow the pole sections to separate
during play and/or transport of the system.
• Climate, corrosion, or misuse could result in system
failure.
• Minimum operational height is 6' 6" (1.98 m) to the
bottom of backboard.
• This equipment is intended for home recreational use
only and NOT excessive competitive play.
• Read and understand the warning label affixed to
pole.
• The life of your basketball pole depends on many
conditions. The climate, placement of the pole,
location of the pole, exposure to corrosives such as
pesticides, herbicides, or salts are all important.
•
If technical assistance is required, contact Customer
Service.
• Adult supervision is recommended when adjusting
height.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY, PROPERTY DAMAGE AND
WILL VOID WARRANTY.
Owner must ensure that all players know and follow these
rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system
without following the instructions carefully. Proper and
complete assembly, use and supervision is essential for
proper operation and to reduce the risk of accident or injury.
A high probability of serious injury exists if this system is not
installed, maintained, and operated properly. Check entire box
and inside all packing material for parts and/or additional
instructional material. Before beginning assembly, read the
instructions and identify parts using the hardware identifier
and parts list in this document.
25
4
ID# M732211 05/06
IMPORTANT!
Remove all contents from boxes.
Be sure to check inside pole sections;
hardware and additional parts are packed inside.
NOTICE TO ASSEMBLERS
Adult Assembly Required. Dispose of ALL packaging materials promptly. As with all products,
periodically inspect for loose small parts.
ALL basketball systems, including those used for DISPLAYS, MUST be assembled and installed
according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is
NOT acceptable to devise a makeshift support system.
PRODUCT REGISTRATION:
Please remember to complete your product registration form online at:
www.huffysports.com/customer_support/product_registration.
WARNING: IF YOUR SYSTEM IS EQUIPPED WITH AN ACRYLIC
BACKBOARD, EXAMINE BACKBOARD FOR ANY DAMAGE THAT MAY
HAVE OCCURRED DURING SHIPMENT. CRACKS IN THE BACKBOARD
COULD RESULT IN SUDDEN BREAKAGE. IF BACKBOARD IS DAMAGED
IN ANY WAY PRIOR TO OR AFTER ASSEMBLY, CALL TOLL-FREE
NUMBER:
U.S. 1-800-558-5234; CANADA: 1-800-284-8339; http://www.huffysports.com
05/06 ID# M732211
5
Get to know the basic parts of your basketball system...
RIM
POLE
BASE
BACKBOARD
FRONT VIEW
ELEVATOR ADJUSTMENT
SUPPORT STRUT
6
ID# M732211 05/06
PARTS LIST - See Hardware Identifier
NOTE: Hardware kit is designed for more than one style of basketball system.
Not all hardware will be used.
Item Qty. Part No. Description
1 1 206657 Tank, (Black)
2 1 200628 Wheel Axle
3 2 226401 Wheel, 4” (Black)
4 1 908242 Top Pole Section
5 1 908246 Middle Pole Section
6 1 908247 Bottom Pole Section
7 1 202820 Rod, 3/8 O.D. x 4-3/4 Long
8 1 202822 Eyebolt, 3/8-16 x 2-1/2 Long
9 2 203063 Lock Nut, 3/8-16
10 2 906206 Tank Strut
11 1 201625 Bolt,Yellow Dichromate, 5/16-18 X 3.60
Long
12 6 203218 Washer, Flat, 5/16
13 1 203099 Lock Nut, 5/16-18
14 1 203493 Nut, Hex Head, 3/8-16 x 0.625 Long
15 2 205528 Bolt, Hex Flange, 5/16-18 x 1 Long
16 8* 203100 Nut, Hex Flange, 5/16-18
17 4 201651 Spacer .500 I.D. x .25 Long
18 2 206303 Washer 1/4 Flat
19 1 200627 Wheel Bracket
20 4 204558 Screw, Phillips, 1/4 x .375 Long, Type 25
21 1 Rim
22 1 206219 Cap, Pole Top 3”
23 1 202603 Washer, Nylon
24 2 203617 Plug Cap
Item Qty. Part No. Description
25 1 522730 Label, Height Adjustment and Moving
26 1 Net
27 1 201160 Pawl Lever
28 1 801159 Ratchet
29 2 900846 Backboard Bracket
30 1 203472 Spring, Black, Slam Jam
31 1 200318 Bracket, Reinforcement, Slam Jam
32 1 900033 Bracket Slam Jam
33 4 202587 Spacer .520 I.D. x .750 O.D. x 1.0 Long
34 1 206305 Clevis Pin 1/4 x 2-3/8 Long
35 1* 206360 Bolt, Hex 3/8-16 x 2.65 Long
36 1 203796 T-Bolt, 3/8-16 x 5 Long
37 1 203470 Washer Flat, Slam Jam
38 7 206340 Lock Nut 1/2-13
39 1 203795 Nut, Special, Slam Jam
40 1 201125 Spring, Ratchet Return
41 4 206311 Spacer .520 I.D. x .750 O.D. x .50 Long
42 7 206304 Bolt 1/2-13 x 6-5/16 Long
43 4 908178 Elevator Tubes
44 2* 201129 Spacer .402 I.D. x .500 O.D. x 1.8 Long
45 1 201642 Spacer Plastic, .63 Long
46 1 281159 Handle
47 1 908176 Tube, Handle, Outer
48 1 908177 Tube, Handle, Inner
49 1 240017 Bolt, Hex 1/4-20 x 2.25 Long
50 2 203038 Bolt, Carriage, 5/16-18 x 2.75 Long,
51 4 203113 Bolt, Hex Flange, 5/16-18 x 2.5 Long
52 1 203365 Spacer, Rim
* You many have extra parts with this model.
05/06 ID# M732211
7
* You may have extra parts with this model.
HARDWARE IDENTIFIER (BOLTS & PINS)
Item #12 (6)
Item #13 (1)
Item #15 (2)
Item #14 (1)
Item #9 (2)
Item #18 (2)
Item #38 (7)
Item #39 (1)
Item #16 (8*)
Item #23 (1)
Item #34 (1)
Item #8 (1)
Item #20 (4)
Item #42 (7)
HARDWARE IDENTIFIER (NUTS & WASHERS)
Item #11 (1)
Item #51 (4)
Item #50 (2)
Item #36 (1)
Item #37 (1)
Item #49 (1)
Item #35 (1*)
Loading...