Huffy NT9110 User Manual

2.04 Mb
Loading...

A Huffy Sports Company WRITE IN YOUR MODEL NUMBER:

Customer Service

N53 W24700 South Corporate Circle

Sussex, WI 53089

U.S.A.

Portable Basketball System

Owners Manual

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the unit.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire pallet and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document. Proper and complete assembly, use and supervision are essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

This equipment is intended for home recreational use only and NOT excessive competitive play.

Read and understand the warning label affixed to pole. Label is shown on page 2.

The life of your basketball pole depends on many conditions. The climate, placement of unit, the location of unit, exposure to corrosives such as pesticides, herbicides or salts are all important.

During assembly, if using a ladder use extreme caution. Two people are recommended for this operation.

Climate, corrosion and excessive use or misuse could result in pole failure.

If technical assistance is required, contact Customer Service Center.

Adult supervision is recommended when adjusting unit.

Minimum operational height is 6’ 6” (2 m) to the bottom of backboard.

Most injuries are caused by misuse and/or not following instructions. Use caution when using this unit.

IMPORTANT! Have questions?...Don’t go back to the store!

NOTICE TO ASSEMBLERS

ALL Huffy Sports basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is

NOT acceptable to devise a makeshift weight system.

REQUIRED TOOLS AND

MATERIALS:

Two People

Carpenters Level

Wrench: 3/4” Or Small Adjustable

Combination Wrenches: (Two) 1/2”, 9/16”

Step Ladder 8 ft. (2.4 m)

Utility Knife

Reversible Drill with 3” Phillips and Standard Screwdriver Tips

Ballast (Sand or Dry Cement 480-640 lbs.(218-290 kg))

We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to answer any questions, please contact our Toll-Free Customer Service Number listed below. Service will be quicker if you have your

Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN THE SPACE PROVIDED ABOVE.

Toll-Free Customer Service Number for U.S: 1-800-558-5234 Canada Only: 1-800-284-8339

Internet Address: http://www.hydra-rib.com

 

printed on recycled paper

1

07/01

P/N 211550A

 

 

 

 

 

 

 

WARNING

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

Owner must ensure that all players know and follow these rules for safe operation of the unit.

·See instruction manual for proper installation and maintenance.

·Use caution when performing dunk type activities on this unit.

·Do not hang from any part of unit, including backboard, support braces, rim or net.

·Do not slide, climb or play on base and/or pole.

·Surface beneath the base must be smooth and free of gravel.

·After assembly is complete, distribute ballast and stake to the ground.

·Never leave unit in an upright position without placing required amount of ballast in base, as unit may tip over causing injury.

·Keep organic material away from base. Grass, litter, etc. could cause corrosion and/or deterioration.

·Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through steel anywhere, replace pole immediately.

·Check unit before each use for loose hardware, excessive wear and signs of corrosion and repair before using.

·Check unit before each use for stability.

·Do not use system during windy and/or severe weather conditions, unit may tip over. Place system in the storage position and/or in an area protected from the wind and free from personal property and/or overhead power lines.

·During play, use extreme caution to keep player's face away from the backboard, rim or net.

·When adjusting height or moving unit, keep hands and fingers away from moving parts.

·Do not allow children to move or adjust unit.

·During play, do not wear jewelry (rings, watches, necklaces, etc.) Objects may entangle in net.

211411 1/98

P/N 211550A 07/01

2

 

 

 

 

 

 

IMPORTANT! WRITE DOWN MODEL NUMBER FROM BOX ON PAGE 1 OF THIS OWNERS MANUAL

1. Use a fork lift to remove unit from truck and carefully remove packing materials.

2. Remove backboard, lower pad (1) and both shroud covers (2 and 3).

 

IMPORTANT!

 

 

 

 

DO NOT REMOVE

 

 

 

 

STABILIZING STRAP

 

 

3

 

AT THE REAR OF MAIN POST

 

 

 

 

AT THIS TIME!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WA

RNING

B

ACKBO

ARD

2

1

W

A

RN

IN

G

REMOVE AND

DISCARD SCREWS

3. Remove the three screws which hold base to pallet and carefully lay unit base forward down to floor. Discard screws.

WARNING

TWO PERSON MINIMUM

REQUIRED FOR THIS

PROCEDURE.

NOT FOLLOWING

RECOMMENDATION MAY

RESULT IN BODILY INJURY.

3

07/01

P/N 211550A

 

 

 

 

Ballast Installation

 

 

 

4.

Remove extension arm (4) from slide post

 

4

 

 

 

 

brackets as shown.

 

 

 

 

 

 

 

 

 

 

 

R

 

 

 

 

 

 

 

 

S

 

 

G

BACK VIEW

4

 

D

 

 

 

 

 

IN

 

 

 

 

 

 

N

 

 

 

 

 

 

 

AR

 

 

 

 

 

 

 

W

 

 

 

 

 

 

 

 

 

 

IMPORTANT!

 

 

 

 

 

 

 

 

SET BRAKE

 

 

 

 

 

 

 

 

AT THIS TIME.

5.

Cut stabilizing strap and set brake so unit will

 

 

 

 

 

 

not roll.

 

 

 

 

 

 

6. Raise main post upward into playing position.

 

 

 

 

 

 

 

 

W

 

 

 

 

 

 

 

 

A

 

 

 

 

 

 

 

 

RN

7.

 

 

 

 

 

 

 

ING

Tighten nut located at top of pole behind mast.

 

 

 

 

 

 

 

 

 

(Flat wrench (5) included.)

 

 

 

 

 

 

 

 

NDS

 

 

 

 

 

 

 

 

R

 

 

 

 

 

 

 

 

5

P/N 211550A

07/01

 

4

 

 

 

 

 

 

 

 

 

 

WARNING

DO NOT USE UNIT

WITHOUT BALLAST

MAY TIP OVER.

 

BALLAST

 

 

80 LB (36 KG)

 

BALLAST

80 LB

(36 KG)

 

 

 

 

80 LB (36 KG)

 

 

 

80 LB (36 KG)

 

 

 

 

B

ST

BAL

 

80

KG)

80LB

 

80

KG)

80LB

8. Attach lower front pad (1) to unit as shown.

1

8

7

6

1

9. Install 640 lbs. (290 kg) of ballast. Secure with straps.

NOTE: Equal weight on each side required.

3

 

 

 

10. Install shroud cover (3) as shown.

 

 

 

Repeat for opposite side.

 

 

 

 

3

 

 

 

9

10

 

 

 

 

5

 

07/01

P/N 211550A

 

 

+ 10 hidden pages