Huffy M731321 User Manual

11/05 ID# M731321

Toll-Free Customer Service Number for U.S: 1-800-558-5234,

For Canada: 1-800-284-8339,

For Europe: 00 800 555 85234 (Sweden: 009 555 85234),

For Australia: 1-800-632 7921

Internet Address: http://www.huffysports.com

REQUIRED TOOLS

AND MATERIALS:

AND/OR

OPTIONAL TOOLS

AND MATERIALS:

Portable System

Owners Manual

Customer Service Center

• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.

READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT.

FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY.

WARNING!

1/2" 9/16" 3/4"

• 2 People

• Tape Measure

• Wood Board (scrap)

• Sawhorse or Support Table

• Safety Glasses

• Step Ladder - 8ft. (2.4 m)

• #2 or #3 Phillips Screwdriver

SAND

(300 lb.)

(136 kg)

Write Model Number

From Box Here:

• (2 each) Wrenches and/or Socket Wrenches and Sockets (DeepWell Sockets are Recommended).

• Extension is Recommended.

• Large and Small Adjustable

Wrenches

• Garden Hose or Sand

ID# M731321 11/05

BEFORE YOU START!

To ensure optimal playability of backboard

system, a close tolerance fit between the

elevator components and hardware is

required. Test-fit large bolts into large

holes of elevator tubes, backboard

brackets, and triangle plates. Carefully

rock them in a circular motion to ream out

any excess paint from holes if necessary.

Not all items pictured are included with

every model.

Owner must ensure that all players know and follow these rules

for safe operation of the system.

WARNING

•

DO NOT HANG on the rim or any part of the system including backboard, support braces or net.

•

During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.

•

Do not slide, climb, shake or play on base and/or pole.

•

After assembly is complete, fill system completely with water or sand and stake to the ground. Never leave system in an upright position without filling base with weight, as system may tip over causing injuries.

•

When adjusting height or moving system, keep hands and fingers away from moving parts.

•

Do not allow children to move or adjust system.

•

During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.

•

Surface beneath the base must be smooth and free of gravel or other sharp objects. Punctures cause leakage and could cause system to tip over.

•

Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.

•

Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately.

•

Check system before each use for proper ballast, loose hardware, excessive wear and signs corrosion and repair before use.

•

Check system before each use for instability.

•

Do not use system during windy and/or severe weather conditions; system may tip over. Place system in the storage position and/or in an area protected from the wind and free from personal property and/or overhead wires.

•

Never play on damaged equipment.

•

See instruction manual for proper installation and maintenance.

•

When moving system, use caution to keep mechanism from shifting.

•

Keep pole top covered with cap at all times.

•

Do not allow water in tank to freeze. During sub-freezing weather add 2 gallons of non-toxic antifreeze, sand or empty tank completely and store. (Do not use salt.)

•

While moving system, do not allow anyone to stand or sit on base or have added ballasting on base.

•

Do not leave system unsupervised or play on system when wheels are engaged for moving.

•

Use Caution when moving system across uneven surfaces. System may tip over.

•

Use extreme caution if placing system on sloped surface. System may tip over more easily.

Read and understand warnings listed below before using this product.

Failure to follow these warnings may result in serious injury and/or property damage.

ID#: 556790 01/05

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

In the U.S.: 1-800-xxx-xxxx

Canada: 1-800-xxx-xxxx

11/05 ID# M731321

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts and/or additional instruction material. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document. Proper and complete assembly, use, and supervision are essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this system.

• If using a ladder during assembly, use extreme caution.

• Two (2) people are recommended for this operation.

• Check base regularly for leakage. Slow leaks could cause system to tip over unexpectedly.

• Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to separate during play and/or transport of the system.

• Climate, corrosion, or misuse could result in system failure.

• Minimum operational height is 6' 6" (1.98 m) to the bottom of backboard.

• This equipment is intended for home recreational use only and NOT excessive competitive play.

• Read and understand the warning label affixed to pole.

• The life of your basketball pole depends on many conditions. The climate, placement of the pole, location of the pole, exposure to corrosives such as pesticides, herbicides, or salts are all important.

• If technical assistance is required, contact Huffy Sports.

• Adult supervision is recommended when adjusting height.

ID# M731321 11/05

IMPORT

ANT!

Remove all contents from boxes.

Be sure to check inside pole sections,

hardware and additional parts are packed inside.

WARRANTY CARD:

Please remember to complete your product registration form either on-line at: www.huffysports.com/customer_support/product_registration or mail-in the enclosed postcard.

WARNING: IF YOUR SYSTEM IS EQUIPPED WITH AN ACRYLIC BACKBOARD, EXAMINE BACKBOARD FOR ANY DAMAGE THAT MAY HAVE OCCURRED DURING SHIPMENT. CRACKS IN THE BACKBOARD COULD RESULT IN SUDDEN BREAKAGE. IF BACKBOARD IS DAMAGED IN ANY WAY PRIOR TO OR AFTER ASSEMBLY, CALL TOLL-FREE NUMBER: U.S. 1-800-558-5234; CANADA: 1-800-284-8339; http://www.huffysports.com

NOTICE TO ASSEMBLERS

ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled

and ballasted with sand or water according to the instructions. Failure to follow instructions

could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

11/05 ID# M731321

FRONT VIEW

POLE

SUPPORT STRUT

BASE

Get to know the basic parts of your basketball system...

ELEV ATOR ADJUSTMENT

BACKBOARD

RIM

ID# M731321 11/05

PARTS LIST - See Hardware Identifier

Item Qty. Part No. Description

1 1 206657 Tank, (Black) 2 1 200628 Wheel Axle 3 2 226401 Wheel, 4“ (Black) 4 1 90021701 Top Pole Section 5 1 904840 Middle Pole Section 6 1 900136 Bottom Pole Section 7 1 202820 Rod, 3/8 O.D. x 4-3/4 Long 8 1 202822 Eyebolt, 3/8-16 x 2-1/2 Long

9 7* 203063 Nylon Insert Lock Nut, 3/8-16 10 2 906206 Tank Strut 11 1 201625 Bolt,Yellow Dichromate, 5/16-18 X 3.60" Long 12 6 203218 Washer, Flat, 3/8 I.D. 13 2 203099 Nylon Insert Lock Nut, 5/16-18 14 1 206219 Cap, Pole Top 3” 15 6 205528 Bolt, Hex Flange, 5/16-18 x 1 Long 16 8 203100 Nut, Hex Flange, 5/16-18 17 2 201651 Spacer .500 I.D. x .25 Long 18 5 204804 Screw, Phillips Head, 3/4 Long 19 1 200627 Wheel Bracket 20 1 Rim 21 5 206340 Nut 1/2-13 22 5 206304 Bolt 1/2-13 x 6-5/16 Long 23 1 202739 Bolt 5/16-18 x 1.75 Long 24 2 203617 Plug Cap 25 1 211262 Label, Height Adjustment and Moving 26 1 Net 27 1 200209 Pole Mount Bracket 28 2 203231 Bolt, Carriage, 5/16-18 x 3.5 Long 29 2 90096401 Backboard Bracket 30 1 203472 Spring, Black, Slam Jam 31 1 200318 Bracket, Reinforcement, Slam Jam 32 1 900033 Bracket Slam Jam 33 1 200212 Trigger 34 1 206990 Reinforcement Bracket 35 4 204961 Bolt, Hex 3/8-16 x .625 Long 36 1 203796 T-Bolt, 3/8-16 x 5” Long 37 1 204872 Labels Height Indicator 38 1 203470 Washer Flat, Slam Jam 39 2 203678 Bolt, Hex, 3/8-16 x 6.5" Long 40 1 203795 Nut, Special, Slam Jam 41 2 902537 Lower Elevator Tubes 42 4 201642 Spacer .530 I.D. x.5 O.D. x .63 Long 43 1 204838 Spring, Elevator 44 2 900184 Upper Elevator Tubes 45 1 200215 Cross Pin 46 1 200214 Locking Pin 47 1 200211 Left Handle 48 1 200210 Right Handle 49 1 900006 Adjustment Tube - Upper 50 1 200257 Spring 51 2 202862 Spacer .563 I.D. x 1.19 Long 52 1 908109 Adjustment Rod - Lower

NOTE: Hardware kit is designed for more than one style of basketball system. Not all hardware

will be used.

* You may have extra parts with this model.

11/05 ID# M731321

HARDWARE IDENTIFIER (BOLTS AND SCREWS)

HARDWARE IDENTIFIER (NUTS AND WASHERS)

Item #8 (1)

Item #11 (1)

Item #12 (6)

Item #13 (2)

Item #15 (6)

Item #16 (8)

Item #9 (7*)

Item #18 (5)

Item #28 (2)

Item #39 (2)

Item #21 (5)

Item #38 (1)

Item #22 (5)

Item #35 (4)

Item #23 (1)

ID# M731321 11/05

HARDWARE IDENTIFIER (STEEL SPACERS)

HARDWARE IDENTIFIER (PLASTIC SPACERS, CAPS, CLIPS AND OTHER)

Item #42 (4)

Item #31 (1)

Item #51 (2)

Item #46 (1)

Item #45 (1)

Item #40 (1)

Item #32 (1)

Item #17 (2)

Item #30 (1)

Item #7 (1)

Item #36 (1)

11/05 ID# M731321

Correctly identify each pole section. Poles have an identification sticker that will be used as a

reference point in the next step.

ITEMS REQUIRED FOR THIS SECTION

9/16”

1/2”

This is what your system will look like when you’ve finished this section.

(2) 1/2” and (2) 9/16" Wrenches

(2) Socket Wrenches and Sockets

AND/OR

SECTION A: ASSEMBLE THE BASE

MIDDLE

BOTTOM

TOP

Identification Sticker

+ 19 hidden pages