Hubbell 31.130 User Manual
Hubbell Industrial Controls, Inc.
License
Free Radio
Control
Systems
120V AC Single & Two Speed
Hubbell Radio Remote Control Systems
Spec Sheet 31.130 • October 2000
Replaces: Catalog Sheet 31132 License-Free Radio
• System approved for operation
under FCC Part 15 rules — no user license
required.
• Digital FM signal — exceptional immunity to
noise.
• Security — 65,000+ address codes
available, user settable by dip switch
• State of the art design — surface mount, micro-
controller electronics.
• Auto power off extends battery life.
• Extremely compact and cost effective systems.
Select one of several single-speed transmitters or
a two-speed transmitter:
• Key-Ring - with 1 or 4 buttons
• Belt-Clip - with 1, 2, 3, 4, or 6 buttons
• Hand-Held - with 6 or 8 buttons
• Hand-Held -- with 8 two-speed buttons.
All transmitters are rated NEMA 3 for indoor/
outdoor use.
Single Speed Control
System Features
• Extremely compact and cost effective
Remote Control Systems
• Output relays are individually settable
for momentary or latched function
• Highly reliable and secure operation
• Meets FCC Part 15 rules: no user
license required
Four Relay Receiver with Key Ring
& Belt Clip Transmitter
Two Speed Control
System Features
• Extremely compact and cost effective
Remote Control Systems
• Output relays are individually settable
for momentary or latched function
• Highly reliable and secure operation
• 32 frequencies in the 430 MHz FM
band
• Active E-Stop
• Meets FCC Part 15 rules: no user
license required
Eight Relay Receiver
with “Stop”
Select receivers with the number of output relays
to match the transmitter functions. A flexible
half–wave antenna mounts directly to the
receiver by BNC connector. All receivers are
rated NEMA 4X for indoor/outdoor use.
HUBBELL
Single Speed
Specifcations
Two Speed
Specifcations
Hand Held Two Speed
Transmitter with “E–Stop”
(with optional rubber boot)
16 Relay Receiver with “E–Stop”
HUBBELL
Hubbell Industrial
Controls, Inc.
a subsidiary of
Hubbell Incorporated
50 Edwards Street
Madison, Ohio 44057
(440) 428-1161
Fax (440) 428-7635
4301 Cheyenne Drive
Archdale, NC 27263
(336) 434-2800
Fax (336) 434-2801
Transmitter Specifications
• Built-in antenna
• Frequency: 433 MHz, FM
• Digital pulse transmission
• LED to indicate “transmitting/battery low”
• For indoor and outdoor use: NEMA 3 and
IP 54
Key-Ring Transmitter
• 1 or 4 pushbuttons
• 12 Volt alkaline battery
• Operating time: 15 hours continuous
• Approx. weight: 1 oz. with battery
• Approx. size: 3” x 1” x
1
⁄2”
Belt-Clip Transmitter
• 1, 2, 3, 4, or 6 pushbuttons
• 9 Volt alkaline battery
• Operating time: 24 hours continuous
• Approx. weight: 4 oz. with battery
• Approx. size: 4” x 2
1
⁄2” x 1”
Hand-Held Transmitter
• 6 or 8 pushbuttons
• 9 Volt alkaline battery
• Operating time: 15 hours continuous
• Approx. weight: 9 oz. with battery
• Approx. size: 6” x 3” x 1
1
⁄2”
Hand-Held Transmitter
with “Stop”
• 4, 6 or 8 pushbuttons, push/pull switch
for “Stop/Run”, key-switch for transmitter
“On/Off”
• Rechargeable lithium battery
• Operating time: 30 hours continuous
• Recharge time: 3 hours
• Approx. weight: 10 oz. with battery
• Approx. size: 6” x 3” x 1
1
⁄2”
Receiver Specifications
• Double superheterodyne
• Sensitivity -110 dBm or better at 20 dB S/N
• Frequency: 433 MHz, FM
1
•
⁄2 wave flexible antenna
• Output relays rated 8 Amp at 250V ac
• For indoor and outdoor use: NEMA 4X
and IP 65
• For operation from 120V ac power, or
optionally: 12/24V dc; 12/24V ac
4 Relay Receiver
• 4 output relays
• Approx. size: 5” x 5” x 2”
4 Relay Receiver with “Stop”
• 4 output relays
• 1 “stop” relay
• Approx. size: 5” x 5” x 2”
6 Relay Receiver
• 6 output relays
• Approx. size: 8” x 5” x 2
1
⁄2”
6 Relay Receiver with “Stop”
• 6 output relays
• 1 “stop” relay
• Approx. size: 8” x 5” x 2
1
⁄2”
8 Relay Receiver
• 8 output relays
• Approx. size: 8” x 5” x 2
1
⁄2”
8 Relay Receiver with “Stop”
• 8 output relays
• 1 “stop” relay
• Approx. size: 8” x 5” x 2
1
⁄2”
Transmitter Specifications
• Built-in antenna
• Digital pulse transmission
• LED to indicate “transmitting/battery low”
• 2 LED’s to indicate selected function
• For indoor and outdoor use: NEMA 3 and
IP 54
Hand-Held Transmitter
with “E-Stop”
• Eight 2-speed pushbuttons, push/pull
switch for “E-stop/Run”, key-switch for
transmitter “On/Off”
• Automatic “power off”, user settable for
2, 6, 12 minutes, or manual
• Rechargeable lithium battery
• Operating time: 12 hours continuous
• Recharge time: 1
• Approx. weight: 10 oz. with battery
• Approx. size: 6” x 3” x 1
1
⁄2 hours
1
⁄2”
Receiver Specifications
• Double superheterodyne, synthesized
• Sensitivity -110 dBm or better at 20 dB S/N
1
•
⁄2 wave flexible antenna
• Output relays rated 16 Amp at 250V ac
• For indoor and outdoor use: NEMA 4X
and IP 65
• For operation from 120V ac power, or
optionally: 12/24V dc; 12/24V ac
9 Relay Receiver with “E-Stop”
• 9 output relays
• 2 “E-Stop” relays
• Approx. size: 9” x 6” x 3
1
⁄2”
16 Relay Receiver with “E-Stop”
• 16 output relays
• 2 “E-Stop” relays
• Approx. size: 12” x 9” x 2
1
⁄2”
JPS-100-1M © 2000
Printed in U.S.A.
http://www.hubbell-icd.com/radiocontrols/
Hubbell Industrial Control Solutions
Loading...