Huawei EM701 Installation Manual
Copyright © 2009 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this document may be reproduced or transmitted in any form or by any means without
prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd.
All other trademarks and trade names mentioned in this document are the property of their
respective holders.
Notice
The information in this document is subject to change without notice. Every effort has been made in
the preparation of this document to ensure accuracy of the contents, but all statements,
information, and recommendations in this document do not constitute the warranty of any kind,
express or implied.
Table of Contents
Getting to Know the EM701.......................................................................................................... 1
Preparing the EM701..................................................................................................................... 3
Installation Guide........................................................................................................................... 4
Safety Information.........................................................................................................................8
i
Thank you for purchasing Huawei EM701 Wireless Module.
Note:
This manual briefly describes the preparation, the process for installing/uninstalling, and safety
precautions for using Huawei EM701 Wireless Module (hereinafter referred to as the EM701).
You are recommended to read the manual before using the EM701.
The signal strength and the transmission rate are affected by the actual environment.
Getting to Know the EM701
The following figure shows the appearance of the EM701. The actual product may differ.
2
3
1
2
2
1
n BTB Connector
It is used to connect to the interface of the PC.
o Screw holes
They are used to fix the EM701 on the main board of the PC with screws.
p Antenna interfaces
It is used to connect an antenna.
Requirements for the User Side
To use the EM701, the user must meet the following requirements:
60-pin Board to Board Connector interface.
Windows CE/Windows XP/Linux 2.6.18 or later versions
Display resolution: 800 × 600 or above.
The antenna gain：900M<2.1dBi, 1800M<2.6dBi,2100M<4.3dBi,
850M<2.75dBi,1900M<2.5dBi
2
Loading...