HP xb31 User Manual

Ceiling Mount User’s Guide

Drill four holes into the structural ceiling

u

member.
Attach the ceiling rod to the ceiling with the
four cylinder screws.

Be sure to install the
projector into a solid,
structural ceiling member:

Ceiling Mounting Procedure:

4

HP recommends that a
competent carpenter or
electrician install this
ceiling mount.

v

Mount the projector to
the ceiling mount bracket
with the three bracket
screws.

Before installation, refer to the

Structural Ceiling

Cylinder Screw

Adjusting the Projected

“
Image” section of the Projector

Three Bracket Screws

User’s Guide f or the projection
distance based upon the de­sired image size. Use this
projection distance to locate the
ceiling mount.

Ceiling Rod

wx

Make necessary roll and yaw adjustments to the
projector.

Attach the ceiling bracket to the ceiling rod with
the round thumbscrew. Height adjustments can
be made by using different holes on the ceiling
rod and ceiling bracket.

The total adjustment range is15.75 to

vv

v

vv

25.6 inches (40~65cm). Adjusments can be made
in one inch (2.5cm) increments.

Round Thumbscrew

Ceiling Bracket

(YAW ADJUSTMENT)

180°

±60°

Adjust the appropriate ceiling projection image mode from the “Management” menu tab in the

vv

v

vv

on screen display.

(ROLL ADJUSTMENT)

±20°

P/N 36.85807.001-A