HP RG5-1557, RG5-1410, RF5-0302, RB1-1411, RB1-1386 User Manual

800-551-1943

HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 1
LJ 4V | 4MV Series Maintenance Kit:

1 HP RG5-1557 Fusing Assembly
1 HP RF5-0302 Separation Pad
1 HP RB1-1411 MP Pickup Roller
1 HP RG5-1410 Transfer Roller
2 HP RB1-1386 Dual Pickup Roller

Please Note: Turn the printer off, unplug it, and allow it to sit for 30 minutes before
performing these maintenance procedures.

This printer maintenance kit provides you with the parts most commonly used to rebuild HP LaserJet 4V/4MV printers.
Using the HP LaserJet Printer Maintenance Kit helps you eliminate repeat service calls and maximize the paper feed and
print quality performance of your laser printer.

Recommended Maintenance Level:
The parts included in this kit have a variable service life that is highly dependent upon printer applications, operating
environment, user maintenance and the print media used. Any printer servicing should include inspection of the
components, particularly in the presence of error messages and/or image defects.

Caution: Please be sure to refer to your printer service manual for detailed instructions
on how to remove and replace these printer parts.

Fusing assembly removal and replacement

The Fusing assembly is located on the upper portion of the printer door.

1). Remove the Transfer Roller
Handle the Transfer Roller from the ends only. Do not touch the surface of the Transfer Roller. Skin oils will affect its
electrical characteristics, resulting in poor image transfer.
a). Grasp the shaft on either end of the Transfer Roller and lift upward to snap out of the plastic retainer clip (callout 1).
b). Lift the opposite end up and out of its retainer clip.

800-551-1943
HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 2

To Reinstall:
Be sure that the non-gear end of the shaft is to the right.
Also make sure that the alignment slot (plastic tab) on the underneath side of the Transfer Roller slips over the locator pin
(callout 2).

CAUTION Do not remove two screws indicated in by the null symbol

2). Remove five machine shoulder screws (callout 3).
a). Pull outward on the edges of the Front Door assembly to release the shaft (callout 4).
b). Lift the Fusing assembly up and out.

To Reinstall:

CAUTION Make sure that the Protection Plate (callout 5) is in place or damage to the toner cartridge drum will
occur.

Cassette Pick Roller Removal

1) Remove top cover
a. Open front door
b. Remove two screws from right and left side of cover

c. Lift front of cover up slightly and push to the back until cover releases
d. Disconnect display cable and remove cover