HP C6615D User Manual

Refill Instructions - HP C6615D (HP-15)

fig.1

HP DeskJet 810, 812, 815, 825, 840, 842, 845, 920, 940, 3810, 3816, 3820, 3822. HP OfficeJet V45, V40, V30, 5100, 5105, 5110. HP PSC 500, 700, 720, 750, 760, 900, 920, 950. HP Digital Copier 310. HP Copier 500

fig.2

Black Refilling Hole

Items Required

Original HP 15 Cartridge, Syringe & Filling Tube Black Ink 15ml Ball Point Pen, Ink Rubber Plug

Instructions

1. Remove the little bit of tape covering the filling hole on the underside of the cartridge (fig.2)

2. Use a ball point pen to press the ball bearing inside the cartridge. (fig.3)

3. Remove the top from the black ink bottle and using the syringe remove 10ml of black ink

4. Insert the steel filling tube into the filling hole. (fig.5). Push down

into centre of the sponge. IMPORTANT: Cartridge contains a sponge and a slight resistance may be felt.

SLOWLY

5. Inject ink. When ink overflows from filling hole or starts to

leak from print heads cartridge is full. Stop injecting immediately. Blot printer heads with tissue before continuing to fill next colour. IMPORTANT: Clean syringe with water and dry before refilling next colour.

6. After refilling insert plug into the filling hole. (fig.6)

7. Use a bit of tape to seal the plug in place (fig.7)

7. Leave the cartridge to stand overnight on non-absorbent surface this will ensure no

8. Install cartridge and run a priming cycle.

leakage and give the ink time to fully saturate the sponge.

IMPORTANT: DO NOT LEAVE ON TISSUE.

(fig.4)

fig.3

fig.4

fig.5

fig.6

fig.7

PLEASE NOTE: The ink indicator level may need to be turned of Check your HP instructions manual for details.

ORDER REFILLS @ www. .comrefill4