HP 1410-16G User Manual

HP ProCurve 1410-16G Switch Quick Setup Guide

1

2

3

1

2

Power LED = On

For more detailed information to set up your switch, view or download the Installation and Getting Started Guide for your
switch at www.hp.com/go/procurve/manuals.

1. Unpack and check included parts. ■ Documentation kit

2. Prepare for installation. To avoid personal injury or product damage, review the “Safety Precautions” on

page 3.

3. Connect power and verify that the switch power LED turns on. The switch does not contain a power switch. It is

turned on by connecting power through the AC power adapter supplied with your switch.

•Read Me First

• Quick Setup Guide

• Safety and Regulatory information

• Software License Agreement and Hardware Warranty
formation

in

■ Switch

■ Accessory kit (installation hardware)

■ AC power adapter (and power cord, if applicable)

4. Install the Switch Hardware. Turn off the switch before installing the switch hardware.

Table or Desktop: At

tach the four self-adhesive pads
(included in the accessory kit) to the bottom corners of
the switch.

© Copyright 2010 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without
notice.

1

Printed in China
February 2010

5998-0343

*5998-0343*

4. Install the Switch Hardware (Continued)

M-4 tap
screws

Ventilation

Cable tie strap

Wall (or Under-Table):
under-table mounting) is included. Use a #1 Phillips (cross­head) screwdriver and the 20-mm M4 tap screws (included).
For screw positions, see the mounting template on page 4.
(Under-Table: After installation, a third screw
prevent switch movement.)

For wall-mounting, the network ports may face up or down.
Do not
down. (See “Safety Precautions” on page 3.)

Rack Mounting: A speci
brackets to the switch using the eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the
rack.

mount the switch with ventilation ducts facing up or

A special kit for wall-mounting (or

may be used to

al rack-mounting kit is included. Use a #1 Phillips (cross-head) screwdriver to attach the special

5. (Optional) Lock the Switch. Use a Kensington lock or

similar device (not included) to physically secure the switch.

6. Power On the Switch.

Use the cable tie strap to secure the connection.

7. Connect Network Cables.

2