HOTPOINT/ARISTON BCB 7525 E C1 Daily Reference Guide
Quick guide
THANK YOU FOR BUYING A
HOTPOINT-ARISTON PRODUCT
In order to receive a more complete assistance, please
register your product on www . hotpoint . eu/ register
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting
the appliance to the power supply. Connect the appliance to the
power supply it starts the operation automatically. The ideal storage
temperatures for the food are preset in the factory.
CONTROL PANEL
1. 2.
EN
Before using the appliance carefully read the Safety
Instruction.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available). If the audible signal
sounds, it means that the temperature alarm has intervened: press the
button to switch o the acoustic alarms.
1. On/stand-by
2. Refrigerator temperature - Fast cool
FAN*
The Fan improves temperature distribution inside the product,
allowing better preservation of stored food and reduction of excess
humidity. The fan is switched on by default and can be activate/
deactivate manually. The fan operating mode is adjusted based on
product condition. You can turn the fan on/o by pressing the
buttons at the same time for 3 seconds. The lit symbol indicates
that the fan is on. If the ambient temperature exceeds 27°C, or if drops
of water are present on the glass shelves, it is essential that the fan is on
to ensure the proper preservation of the food. Deactivation of the fan
allows energy consumption to be optimised.
Note: the fan restarts automatically after a power cut or after turning o
the appliance. Do not obstruct the air intake area with food items.
ANTIBACTERIAL FILTER*
Remove it from the box placed in the Fruit and vegetable drawer and
insert into the cover of fan. The replacement procedure is included in
the lter box.
and
ON/STANDBY
Press the button for 3 seconds to turn the appliance o. In
Stand-by mode the light in the refrigerator compartment does not turn
on. Press the button again briey to reactivate the appliance.
Note: this does not disconnect the appliance from the power supply.
REFRIGERATOR COMPARTMENT TEMPERATURE
It is possible to set a dierent temperature with the
There are ve possible controls.
• From a less cold temperature
• to a colder temperature
FAST COOL
Press the button
compartment or 6 hours before putting large quantities of food to be
frozen in the freezing zone. When the function is turned on the icon
lights up.
The function automatically turns o after 30 hours, or manually by
pressing the button
Note: avoid a direct contact between the fresh food and the food that is
already frozen To optimise the freezing speed, drawers can be removed
and the food can be placed directly on the bottom of the compartment.
for 3 seconds to quickly cool the refrigerator
again for 3 seconds.
(left)
(right).
button.
* Available only on certain models
FOOD CARE ZONE*
1
2
The drawer is specically designed to maintain a low temperature
to preserve fresh food for longer time (for example , fresh pasta,
sour cream, pesto/salsa,homemade preparation,pastry cream,
pudding,cream cheese , cold cuts, desserts, meat and sh).
“0° ZONE” COMPARTMENT*
The “0°ZONE” compartment is specically designed to maintain a low
temperature and the correct humidity to preserve fresh food for longer
(for example, meat, sh, fruits and winter vegetables).
TURNING ON AND TURNING OFF THE COMPARTMENT
The internal temperature of the compartment is approximately 0°
when the compartment is turned on.
To turn on the compartment, press the button (1) for more than one
second until the symbol (2) lights up. The lit symbol (2) means that the
compartment is working. Press the button (1) again for more than one
second to turn o the compartment. The temperature inside depends
on the general temperature of the refrigerator.
.
.
The internal temperature of the drawer is between +3 °C and -2 °C.
For the correct functioning of the drawer, it is necessary that Vacation
mode option is not selected.
Humidity control technology coupled with Active0 provides the best
food preservation when the food is not completely packed.
For the correct functioning of the “0°ZONE” compartment, it is
necessary that:
• the appliance is turned on;
• the fridge temperature is between +2°C and +6°C;
• the “0°ZONE” compartment is turned on
• Vacation Mode and Stand by are not selected
Note:
- if the symbol does not light up when you turn on the compartment,
check that the drawer is properly inserted; if the problem persists
contact the authorised Technical Assistance Service;
- when the “0°ZONE” compartment is inserted in the appliance you
may hear a faint noise, which you should consider as normal;
Important: be careful when positioning food and containers that are
small in size on the upper shelf of the “0°ZONE“ compartment in order
to prevent them accidentally falling between the shelf and the back
wall of the refrigerator compartment.
REMOVING THE “0° ZONE“ COMPARTMENT
Carry out the following steps:
1. To make it easier to remove the compartment, we recommend
that you empty (and possibly remove) the lower door shelves.
2. Remove the compartment by rotating it upwards.
3. Remove the white plastic shelf under the compartment.
Note: it is not possible to remove the upper shelf and side supports.
To use the “0° ZONE“ compartment again, carefully reposition the
white plastic shelf under the compartment before inserting the drawer
and turning the function back on.
STOP FROST SYSTEM*
The STOP FROST SYSTEM facilitates the defrost procedure for the
freezer compartment.
The STOP FROST accessory is designed to collect some of the frost
that forms in the freezer compartment and it is easy to remove and
clean, therefore reducing the time needed to defrost the freezer
compartment.
PROCEDURE TO CLEAN THE STOP FROST ACCESSORY
1. Open the freezer compartment door and remove the upper
drawer.
To have a larger refrigerator volume and to reduce energy
consumption, it is recommended to remove the “0°ZONE“
compartment.
Clean the compartment and its components occasionally using a cloth
and a solution of warm water (taking care not to submerge the white
plastic shelf under the drawer) and neutral cleaning agents specically
for cleaning the inside of the refrigerator. Do not use abrasive cleaning
agents.
Before cleaning the compartment (also externally) it is necessary
to remove the drawer to disconnect the electrical supply.
To remove the frost on the STOP FROST accessory follow the cleaning
procedure demonstrated below.
Note: if the accessory is jammed or dicult to remove, do not keep
trying to remove it, but proceed with the complete defrost of the freezer
compartment.
Unfasten the STOP FROST accessory and remove it, taking care not
2.
to drop it on the glass shelf below.
* Available only on certain models
Close the door of the freezer compartment.
3.
Loading...