Horizon Fitness Pago 3, PAGO 4 Owner's Manual

EXERCISE BIKE OWNER’S MANUAL

EXERCISE BIKE OWNER’S MANUAL

Read the BIKE GUIDE before using this OWNER’S MANUAL.

PAGO 4PAGO 3

2 3

IMPORTANT PRECAUTIONS

SAVE THESE INSTRUCTIONS

When using an exercise product, basic precautions should always be followed, including the following: Read all instructions
before using this exercise bike. It is the responsibility of the owner to ensure that all users of this exercise bike are adequately
informed of all warnings and precautions. If you have any questions after reading this owner’s manual, contact your local dealer.

4 5

READ AND SAVE ALL INSTRUCTIONS BEFORE ASSEMBLING OR USING TH IS
EXERCISE BIKE. IT IS STRONGLY RECOMMEN DED TO TAKE THE FOLLOWING SAFETY
INSTRUCTIONS.

• CAUTION: If you experience chest pains, nausea, dizziness or shortness of breath, stop exercising immediately and consult your
physician before continuing.

• Use this exercise bike for its intended purpose as described in this manual. Do not use attachments that have not been
recommended by the manufacturer.

• Never operate the exercise bike if it is not working properly, or if it has been damaged. Contact the authorized dealers for
examination and repair.

• Do not use the exercise bike without proper footwear. NEVER operate the exercise bike with bare feet.

• Do not wear any clothing that might catch on any moving parts of this exercise bike.

• Keep hands and feet clear at all times from moving parts to avoid injury. Never turn the pedal cranks by hand.

• Do not dismount the exercise bike until the pedals are at a complete STOP.

• Do not attempt to ride the exercise bike in a standing position at high RPMs until you have practiced at slower speeds.

• Do not insert any object, hands or feet into any openings, or expose hands, arms or feet to the drive mechanism or other potentially
moving part of the exercise bike.

• Do not use any equipment that is damaged or has worn or broken parts. Use only replacement parts supplied by the authorized
dealers.

• Do not operate where aerosol (spray) products are being used or when oxygen is being administered.

• Close supervision is necessary when used near children, invalids or disabled people.

• When the exercise bike is in use, young children and pets should be kept at least 3 meters / 10 feet away.

• Ensure that adjustment levers (seat and handlebar fore-and-aft) are properly secured and do not interfere with range of motion
during exercise.

WARNING

ASSEMBLY

There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the
exercise bike could have parts that are not tightened and will seem loose and may cause irritating noises. To prevent damage to
the exercise bike, the assembly instructions must be reviewed and corrective actions should be taken.

Before proceeding, find your exercise bike’s serial number located on
the front stabilizer tube and enter it in the space provided below.

ENTER YOUR SE RIAL NUMBE R AND MODEL NAME IN TH E BOX BELOW:

» Refer to the SERIAL N UMBER and MODE L NAME when calling for service.

MODEL NAM E: HORIZON EXERCISE BIKE

WARNING

SERIAL N UMBER:

BK

SERIAL N UMBER LOCATION

6 7

PAGO 3
SHOWN

PAGO 4
SHOWN

CRAN K

WATER B OTTLE H OLDER

PULS E GRIP HANDL EBARS

REAR STABIL IZER T UBE

POWE R CORD SOCKE T

CONS OLE

SEAT P OSITI ON ADJU STMEN T KNOB

SEAT P OST TU BE

SEAT H EIGHT ADJUS TMENT K NOB

FRON T STABIL IZER T UBE

SEAT

PEDA LS

SHRO UD

CONS OLE MAS T

CRAN K

WATER B OTTLE HOLDER

PULS E GRIP HANDL EBARS

REAR STABIL IZER T UBE

POWE R CORD SOCKE T

CONS OLE

SEAT P OSITI ON ADJU STMEN T KNOB

SEAT P OST TU BE

SEAT H EIGHT ADJUS TMENT K NOB

FRON T STABIL IZER T UBE

SEAT

PEDA LS

SHRO UD

CONS OLE MAS T

8 9

TOOLS INCLUDE D:

F 13/15mm Flat Wrench
F 5mm L-Wrench (w/ Screw driver)
F 4mm L-Wrench

PARTS INCLUDED :

F 1 Bike Frame
F 1 Console
F 1 Console Mast
F 1 Front Stabilizer Tube
F 1 Rear Stabilizer Tube
F 1 Seat
F 1 Seat Post Tube
F 1 Pulse Grip Handlebar Set
F 2 Pedals
F 1 Water Bottle Holder
F 1 Power Cord
F 1 Hardware Kit

UNPACKING

Unpack the product where you will be using it. Place the exercise bike carton on a
level flat surface. It is recommended that you place a protective covering on your
floor. Never open box when it is on its side.

NOTE: During each assembly step, ensure that ALL nuts and bolts are in place
and partially threaded in before completely tightening any ONE bolt.

NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.

If you have questions or if

there are any missing parts,

contact your local dealer.

NEED HELP?

PRE ASSEMBLY ASSEMBLY STEP 1

A Open HARDWARE FOR STEP 1.

B Attach the REAR FOOT TUBE to the MAIN FRAM E

using 2 ARC WASHERS(B), 2 BOLTS(A).

C Attach the FRONT FOOT TUBE to the MAIN FRAME

using 2 ARC WASHERS(B), 2 BOLTS(A).

HARDWARE FOR STEP 1 :

PAGO 3
PAGO 4

BOLT (A)
M10x1.5Px75L
Qty: 4

ARC WASHER (B)
Φ10.2xΦ20.0x1.5T
Qty: 4

BOLT(A)

REAR FOOT TUBE

FRONT FOOT TUBE

MAIN FRAME

MAIN FRAME

ARC WASHER(B)

BOLT(A)

ARC WASHER(B)

10 11

ASSEMBLY STEP 2

A Open HARDWARE FOR STEP 2.
B Unfold the wire harness located in the frame bracket.

Wrap the end of the wire tie, located at the bottom of
the console mast, around the end of the wire harness.
Pull the wire tie and wire harness up through the
console mast while simultaneously sliding the mast
over the frame bracket.

C Attach the CONSOLE MAST using 4 BOLTS (C), 4

SPRI NG WASHER S (D) and 4 ARC WASHERS (E).

HARDWARE FOR STEP 2 :

PAGO 3
PAGO 4

BOLT (C)
M8x1.25Px15L
Qty: 4

SPRING WASHER (D)
Φ8.2xΦ15.4x2.0T
Qty: 4

ARC WASHER (E)
Φ8.4xΦ17.0x1.0T
Qty: 4

ASSEMBLY STEP 3

A Slide the heart rate wires of the handlebar through

the hole in the handlebar bracket on the CONSOLE
MAST.

B Attach the HANDLEBAR to the CONSOLE MAST

using 4 PRE-IN STALLED SCR EWS.

PAGO 3
PAGO 4

NOTE: Be careful not to pinch any wires while attaching
the console mast.

NOTE: Be careful not to pinch any wires while attaching
the handlebar.

BOLT(C)

SPRING WASHE R(D)

ARC WASHER(E)

MAIN FRAME

CONSOLE MAST

PRE-INSTALLED SCREW

CONSOLE MAST