USER MANUAL
IMPORTANT SAFETY REMINDERS
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
Do not leave the appliance plugged in. Always switch off and
remove the plug from the socket after use, or before cleaning
the appliance or any maintenance task.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised Hoover
service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by Hoover.
When using cleaning tools ensure that the appliance is kept in
the upright (parked) position. This will avoid possible damage
to the carpet or floor covering. When cleaning stairs, do not
position the appliance above you.
Static electricity: some carpets can cause a small build up
of static electricity. Any static discharge is not hazardous to
health.
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
cigarette ends or other similar items.
Do not spray with or pick up flammable liquids, cleaning fluids,
aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not continue to use your appliance if it appears faulty.
Hoover service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised Hoover service
engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
When using the cleaning tools, ensure to always steady the
appliance with your other hand. This will ensure that the
appliance does not fall while in use.
The Environment
The symbol on this appliance indicates that this appliance may not
be treated as household waste. Instead it must be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this appliance, please
contact your local city office, your household and waste disposal service or
the shop where you purchased the appliance.
This appliance complies with the European Directives 2014/35/EU,
2014/30/EU and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio
(MB) Italy
Do not pick up hard or sharp objects, matches, hot ashes,
- 1-
GETTING TO KNOW YOUR CLEANER
HANDLE
Effortless cleaning
with your new
Hoover
PET HAIR & ALLERGEN
REMOVER HOLDER*
HOSE
BIN HANDLE
BIN LID
CREVICE TOOL/
DUSTING BRUSH
HOSE HOOK
PET HAIR & ALLERGEN
REMOVER*
BIN RELEASE
BUTTON
CORD HOOK
SEPARATOR
BIN
BIN BASE
CORD HOOK
HOSE
CONNECTOR
(*Certain models only)
ON/ OFF BUTTON
HANDLE STORAGE
HOLDER
REAR WHEEL
- 2 -
PREPARING TO USE YOUR CLEANER
1. Insert the handle into the
main body of the cleaner.
2. Place the crevice tool /
dusting brush into the tool
holder.
POWER SWITCH SETTING
CLEANING TOOLS
IMPORTANT: When using cleaning tools, the cleaner must be kept
in the upright position, particularly when cleaning stairs.
!
To Detach the cleaning
hose rotate the hose end
anti-clockwise and pull
upwards.
Attach crevice tool to the hose end
connector.
To use the dusting brush function simply
press the button and slide to the end of
crevice tool
.
Switching on and off
1. Plug cord into an electrical outlet.
2. Press the on /off switch to operate
cleaner.
CLEANER RELEASE
Unlock the cleaner by
placing your foot on
the hood and leaning
the handle backward.
For cleaning under low
furniture simply lower
handle to floor.
Fit the Pet Hair & Allergen Remover*
All accessories can fit on the end of the tube.
CLEANING THE STAIRS
IT IS DANGEROUS TO PLACE THE CLEANER ABOVE
YOU WHEN CLEANING STAIRS.
ALWAYS work with the cleaner below you. Ensure it
is positioned up against the bottom step.
- 3 -
WIPER BLADE ASSEMBLY
To obtain the best performance and
1
efficiency ,it is recommended to
assemble the front and back wiper
blade to the soleplate of the nozzle.
Grip the inserted side of the wiper
blade and slide along the slot until the
wiper blade is fully located.
To get a lower push force on the
2
nozzle,you can disassemble the
wiper blade.
lift the end of the wiper blade and
pull it out.
REMOVAL AND EMPTYING OF THE
DUST CONTAINER
To remove the dust container
from the cleaner, press the
bin release button.
The dust container door will open and
you can empty with no contact with
1
2
dust.
IMPORTANT: Do not fill above the MAX level mark
shown on the bin.
!
1
2
HANDLE STORAGE
Remove the hose from the
hose hook, and release the
hose.
Push the handle release button,
then lift the handle assembly
upward.
(*Certain models only)
Insert the tube to the handle
storage holder.
Hold the container over a
bin and push the easy open
button placed at the rear of
the dust container.
- 4 -
MAINTAINING THE DUST CONTAINER AND FILTERS
( PERIODIC MAINTENANCE IS REQUIRED TO MAINTAIN OPTIMUM PERFORMANCE)
Remove the dust container as described
on the previous page.
Hold the dust container lid and with the
other hand rotate the container in a anti-
clockwise direction to release.
Hold the pre-motor filter, then rotate the
bin lid with anti-clockwise direction.
After the pre-motor filter is detached,
pull it out.
Cleaning the Separator
Turn the dust container lid anticlockwise to unlock and lift to take
out.
Lift the separator out from the bin.
Tap the separator over a bin to
remove any dirt/debris.
The pre-motor filter should be washed after every 3 bin
empties. Wash under hand warm water. Remove excess water
and leave to dry for 24 hours.
When completely dry, refit the filter.
<40
Refit the separator and the bin lid.
Whilst holding the lower part to
lock together and twist the bin lid
- 5 -
CHANGING THE BELT OR BRUSH
If your cleaner is not picking up efficiently, the
belt or brush (or both) may need replacing, but
first make sure you have:
• Emptied the dust container
• Cleaned the filters
• Checked for blockages
Remove foot plate
Turn the machine over.
Locate the 6 screws as
shown opposite.
Remove the screws
completely.
IM P O R TA NT: Switch cleaner off
and remove plug from electricity
supply before checking the
brushes or removing hood.
Replace belt
Remove the old belt
then locate the new belt
around the motor spindle
and the brush. Locate the
right hand of the brush
into the cleaner housing .
Hold the brush assembly
and stretch the belt until
brush mountings slot
down into the cleaner
housing.
Rotate the brush to
ensure free movement
of the belt.
CLEARING A BLOCKAGE
IM P O R TA NT: Switch the cleaner off and
remove the plug from electricity supply
!
before dismantling cleaning.
This cleaner is unlikely to become
blocked, except by overfilling of dust
container or accidentally picking
up large solid objects. Cleaning a
blockage is simple.
If cleaning tools were
in use, check cleaning
tool. Next check hose
handgrip.
Turn the cleaner ON
and stretch the hose to
its full length.
Replace opposite
Refit sole plate opposite
secure with screws.
- 6 -
Check that the brushes
are free of debris and
can rotate.
Check for a blockage
in the hose socket.
User checklist
If your cleaner is not working properly run through the following checklist.
1 .Is there a working electricity supply to the cleaner? Check with another
electrical product.
2. Is the dust container full or choked with fine dust? To empty the dust container
see the instructions on page 5/6.
IMPORTANT INFORMATION
Hoover Service
Should you require service at any time, please contact your local Hoover Service
Ofce.
Hoover spares and Consumables
3. Is the hose blocked? To clear a blockage, see the instructions on page 6.
4. Is there a blockage in the cleaner base? To clear a blockage, see the
instructions on page 6.
5. Are the filters blocked? To clear the fitters, see the instructions on page 5.
6. Are the brushes rotating correctly? To check the brushes, see the instructions
on page 6.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in
Working order, has not been assembled in accordance with these instructions or
has been used incorrectly.
IMPORTANT: Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Quality
Hoover’s factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
GUARANTEE STATEMENT
The guarantee conditions for this appliance are as defined by our representative
in the country in which it is sold. Details regarding these conditions can be
obtained from the dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim under the terms of this
guarantee.
Subject to change without notice.
- 7 -
PRINTED IN P.R.C.
48027207-1
Loading...