Honeywell SL62 User Manual
Captuvo SL62 ChargeBase
Quick Start Guide
CAPTUVO62-CB-QS Rev A
4/14
Overview
The ChargeBase is a 4-slot charging cradle that can power four
sleds and charge their batteries in four hours. If the Apple
mini is inserted into the sled, the iPad mini will also be charged.
We recommend use of Honeywell peripherals, power cables,
!
and power adapters. Use of any non-Honeywell peripherals,
cables, or power adapters may cause damage not covered by
the warranty.
®
iPad
Unpacking the ChargeBase
Open the shipping box and inspect the package to see that the following standard items are included:
• One ChargeBase (Model: SL-CB-B)
• One power supply
• One power cord
• Quick Start Guide
These items are needed to operate the ChargeBase. If any items
are missing or anything appears to be damaged, contact your Customer Account Representative. Keep the original packaging in case
you need to return the ChargeBase for service or to store the
ChargeBase while not in use.
Convenient Storage
Since charging terminates when the battery has a full charge, the
ChargeBase is a safe and convenient storage receptacle for your
Captuvo SL62 sled.
Front Panel
Sled Wells (Qty. 4)
Back Panel
Power Supply Connector
Power
The charger requires 24 Volts DC input for battery charging; the
power adapter on the power cable converts the voltage from the
power source to 24 volts DC. Use only a UL Listed power supply,
which has been qualified by Honeywell with output rated at 24VDC
and 5A amps with the device.
Honeywell recommends that you leave the ChargeBase connected
to its power source at all times, so that it is always ready to use.
Connecting Power to the ChargeBase
1. Plug the A/C power cord into the power adapter.
2. Plug the power connector cable into the power connector on the
back panel of the ChargeBase.
3. Plug the A/C power cord into a standard wall outlet.
The ChargeBase is ready to begin charging the sled/iPad mini.
A/C Power Cord
LED
Power Adapter
Power Connector Cable
Charging the Battery
1. Install the battery into the sled.
2. Verify the ChargeBase has power.
3. Slide the sled into one of the four wells. Charging begins
immediately if required by the sled or the iPad mini. If the iPad
mini is installed in the sled, the battery icon at the top of the
screen indicates that it is charging. The sled and the iPad mini
charge simultaneously and completely depleted batteries will be
charged in approximately six hours.
Ensure all components are dry prior to mating sleds/batteries with
!
peripheral devices. Mating wet components may cause damage
not covered by the warranty.
Loading...