Honeywell MN6110, MN7510 Catalog Page

Direct Coupled Damper Actuators—Non-Spring Return

N10 Series: MN6110; MN7510 Non-Spring Return Direct Coupled Actuator, 88 lb-in

The MN7510 is a 88 lb-in (10Nm), non-spring return, direct-coupled, low voltage actuator that accepts adjustable modulating (0/2-10 Vdc) or on/off (SPDT) control for: air dampers, air handling units, ventilation flaps, louvers, and ball valves.

• Declutch for manual adjustment

• Adjustable mechanical end limits

• Removable access cover for direct wiring

• Mountable in any orientation

• Function selection switch for selecting modulating or floating/2-position control

Actuator Type: Damper; Valve Rotational Stroke: 95 ±3 degrees Fail Safe Mode: Non-Spring Return Torque Rating: 88 lb-in. (10 Nm) Dimensions, Approximate: 5.23 in high x 2.60 in wide x 2.44 in deep

(134 mm high x 66 mm wide x 62 mm deep.)

External Auxiliary Switches Available: No Electrical Connections: Enclosed screw terminal strip (22 to 14 AWG) Environmental Rating: NEMA2 Ingress Protection Rating: IP54 Frequency: 50 Hz; 60 Hz Manual operation: Declutch mechanism Mounting: Direct Coupled Maximum Noise Rating, Driving (dBA @ 1m): 35 Rotation to Open: By switch Rotational Stroke Adjustment: Dual Integral Adj. Stops (3 degree

increments)

Compatible Damper Shafts: 1/4 to 1/2 in. square or 3/8 to 5/8 in. round

(6 to 13 mm square or 8 to 16 mm round)

Shaft Adapter Type: U-bolt clamp Supply Voltage: 24 Vac +20%, -15%, 24 Vdc Materials: Plenum rated plastic housing Operating Humidity Range (% RH): 5 to 95% RH, non-condensing Ambient Temperature Range: -5 F to +140 F (-20 C to +60 C) Storage Temperature Range: -22 F to +176 F (-30 C to +80 C) Weight: 1.5 lb (0.68 kg) Includes: Mounting bracket, screws, shaft adapter, water-tight strain-

relief cable fittings

Comments: Integral 1/2 in. NPSM conduit connection. Approvals

CE: 89/336/ECC, 73/23/EEC C-Tick: N314 Underwriters Laboratories, Inc: UL873, Plenum Rated Canadian Underwriters Laboratories, Inc: cUL C22.2 No. 24-93

Commercial

Timing (seconds) Nominal

Product Number Control Signal Feedback

* MN6110A1003/U On/Off; SPDT; Floating — 95 sec — 5 VA 0

* MN6110A1201/U On/Off; SPDT; Floating — 95 sec 30 Vdc max.,

* MN7510A2001/U (0)2-10 Vdc (4-20 mA w/500 ohm resistor);

* MN7510A2209/U (0)2-10 Vdc (4-20 mA w/500 ohm resistor);

* TRADELINE models • SUPER TRADELINE models

On/Off; SPDT; Floating

(0)2-10 Vdc (max. output: ±1.0 mA)

Driving @ 60 Hz

95 sec — 5 VA 0

95 sec 30 Vdc max.,

Switch Ratings

3 A Class II

Powe r Consumption, Driving

5 VA 2

Number of Internal Auxiliary Switch

Components

70-6910 371