Honeywell 5301DOJ User Manual

Model 5301DOJ

STEEL SECURITY SAFE

Read this manual carefully and never store it inside the safe!

Model 5301DOJ

Steel Security Safe with Digital Lock

PACKAGE CONTENTS

1 – Steel Security Safe

1 – Operation Manual

2 – Override Access Keys

4 – “AA” Batteries

1 – Mounting Kit w/ Bolts

ATTENTION

DO NOT RETURN SAFE TO STORE!

For missing parts or difficulty operating your safe, please contact our Consumer Assistance Department by telephone.

Store will not accept returned products without prior authorization. You must first contact our consumer assistance department (See page 7 for contact information).

DIGITAL LOCK OVERVIEW

A - Entry Knob

B - Override Key Cover

C - Green LED

D - Red LED

E - Yellow LED

F - Override Key Lock

G - Override Key

H - Reset Button

I - Battery Compartment

SETUP

STEP1. OPEN SAFE WITH OVERRIDE KEY

1. Remove override key cover with small screwdriver.

2. Insert override key and turn left to unlock safe.

3. Turn knob to right and open safe door.

STEP 2. INSTALL BATTERIES

1. Remove battery compartment (A) cover on inside door. Insert 4 “AA” batteries (included). Ensure the batteries are installed in the correct direction, with regard to polarity (+ and -).

2. Replace the battery cover.

3. Do not close door before testing digital lock.

Note: This safe comes with both a factory preset Master Code of 123456B and a User Code of 159B. Both will open the safe and both must be changed for maximum security. The User Code is the one that you would change as often as you feel the need to. Once the Master Code is set, you can record it in a safe place. This will be helpful if you lose your override access key and have forgotten your User Code, the Master Code will still open the safe if the batteries are good.

STEP 3. PROGRAM A NEW MASTER CODE

1. With door open, press “0” “0” on keypad then press

reset button (C) inside door.

2. Yellow light will come on then enter new Master

Code within 15 seconds.

3. Enter new code (3 to 8 digits) followed by “A” or “B”.

4. Safe will beep and yellow light will turn off.

STEP 4. PROGRAM A NEW USER CODE

1. With door open, press reset button (C) inside door.

2. Yellow light will come on then enter new User Code

within 15 seconds.

3. Enter new code (3 to 8 digits) followed by

“A” or “B”.

4. Safe will beep and yellow light will turn off.

NOTE: The factory pre-set Codes will not work after new Codes are programmed.

+ 5 hidden pages