Homelite SW-278A Instruction Manual
The Fine Lighting Company International Ltd.
Medina House, Fieldhouse Lane, Marlow, Bucks SL7 1TB
Tel: 01628 894 400
Fax: 01628 894 401
Email: sales@thefinelightingcompany.com
Web: www.thefinelightingcompany.com
Technical Helpline: 01628 894 500
All of the Fine Lighting Company™ products include a 1 year warranty
The Fine Lighting Company™ reserve the right to change images,
specifications and prices without prior notice.
+
-
OFF
POWER
AUTO
1.2V /350mAh NiMH
SW-278A
EMBER
2 Solar Deck Lights
Instruction Manual
DECLARATION OF CONFORMITY
We declare under our sole responsibility
that this product is in conformity with the following
standards or standardized documents.
A
pplicable EC Directive:
EC Directive of electromagnetic Compatibility
(89/336/EEC) with amendments
Applicable Harmonized Standard:
EN55015/A2:2002
EN61547/A1:2000
EN61000-6-3/A11:2004
Model: SW-278A
Description: 2 Solar Deck Lights
Mark Pearson
M
anaging Director
SW-278A
EMBER
2 Solar Deck Lights
The solar light comprises of a solar
cell, rechargeable batteries and LED
light source. Light from the sun charges
the batteries during the day and at night
the energy stored in the batteries is
used to power the light.
The length of time the light stays on
for is dependent on the amount of
sunlight the solar panel has been
exposed to during the day.
No other power source or connections
are required.
PACK CONTENTS
2 x Solar mobile deck lights
WARNING
Do not apply pressure to the solar panel.
PRIOR TO USE
Check the pack contents to make sure you
have all the products listed.
Prior to first use, set power switch to "OFF"
position and allow battery to charge for 2 days
under full sunlight. Repeat this procedure every
three months to top up the battery.
Please note, this may take longer if there is not
constant full sunlight.
Decide on an appropriate location for your
product (*see Siting Instructions opposite).
ASSEMBLY INSTRUCTIONS
No assembly required.
SITING INSTRUCTIONS
Solar lights are designed for use outside in an
open (un-shaded) location.
The solar panel should be located where
sunlight can fall directly on the units. Shadows
from buildings, trees, walls, hedges or similar
should be avoided as these will reduce your
light running time.
Avoid locations where light from other sources
will fall on the panel at night (street lights etc)
as this may prevent the light from turning on.
The units can be left outside in rain but
should not be exposed to water jets or
immersed in anyway.
For optimum life, the solar panel should be
protected from weather extremes such as
snow or frost.
Do not position near direct sources of heat
such as patio heaters or barbeques.
The product can be mounted on flat surfaces
such as decking and screwed down if required.
CARE & USE
Periodically wipe clean with a soft dry cloth.
Never use scourers, abrasives or chemical
cleaners. Do not allow water to come into
contact with electric components.
The solar panel lens should be cleaned
periodically to ensure its efficiency is not
reduced by dust and dirt.
Some condensation may form inside the lights
or solar panel in cold conditions. This is
normal and will not affect the performance of
your light.
X 2
X 2
NiMH
OFF
POWER
AUTO
1.2V / 350mAh NiMH
OFF
POWER
POWER
AUTO
X 2
OFF
POWER
AUTO
1.2V / 350mAh NiMH
OFF
POWER
POWER
AUTO
CA
UTION
Please be aware children should not use these as toys and care should be taken at all times.
1 Turn power switch
to OFF
2 Unscrew the five
screws on the base of
the product
3 Lift off the base plate
4 Remove old battery
5 Insert new battery
(ensuring + terminal
meets with + battery
end)
6 Replace base plate
7 Screw the five screws
back in to place
8 Turn power switch to
ON / AUTO
PRODUCT DISPOSAL
NiMH battery must be recycled or disposed of properly.
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
“
R
yobi takes the care of our environment very seriously. Please dispose of all waste electrical
and electronic equipment in a responsible and environmentally friendly way.”
BATTERY REPLACEMENT
PRODUCT SPECIFICATIONS
Product Size 12cm (L) x 12cm (W) x 1.7cm (H)
Solar Cell 0.12W Multi Crystal
Light Source Type 1 x White LED (per unit)
Laser Category Class 1
Surface Material Brushed Stainless Steel
Battery Type 1 x 1.2V NiMH (AAA) 600mAh (per unit)
Maximum UK operating Time (summer) 8 hrs
Maximum UK operating Time(winter) 3 hrs
Maximum operating Time (full charge) 10 hrs
Loading...