MANUEL DE L’UTILISATEUR. . . . . . . =. . . . . . page26
‘-NOTICE
~Tbe information in this d~ument is subject to change without notice.
.-Hitachi assumes no responsibility for any errors that may appear in this docu-
~ment.
COkmr Monitor14MVX
OperatingChide
Features
The following features are provided with the HITACHI colour
Monitor 14MVX.
Wide compatibility range of graphics standard, VGA, 8514/A,
Super VGA, and Macintosh II Video Card.
Sharp focus and remarkable display quality by new design CRT.
Cubic and Simple design cabinet with Tilt and Swivel base.
No ventilation holes on top of the cabinet for better safety.
LMF and LEF
This version of 14MVX is built to meet Swedish requirements for
Low Magnetic Field and Low Electrostatics Field. Both features
are to reduce the suspected effects of magnetic field and Electrostatics field to your health down to the TCO recommendation level.
ApF4e d Mncintoshare r+tercd !mdemmksof theApple (bmfmtcr, Lx..
Mncintmh II Video Card is atrademarkof Apple Ccmputcr,Inc..
214MVXUser Manual
—
@EIi@
NEVER REMOVETHE BACK COVER
Removalof the back cover MUST be carried out only by
qualifiedpersonnel.This display monitorcontainshigh voltages
inside.
DO NOT USE IN HOSTILEENVIRONMENTS
DO NOT expose this display monitorto rain or moistureto
prevent electricshock or fue hazard.This unit is designedto be
used in the office or home environment.
DO NOT subject the unit to vibrations,dust, or corrosivegases.
KEEP IN A WELLVENTILATEDPLACE
DO NOT cover this monitoror place anythingagainst the sides.
Ventilationholes are providedon the cabinet to prevent
the temperaturefrom rising.Ventilationholes are also provided
on the bottom of the cabinet.
E
m
-
E
■
.
AVOID HEAT
Avoid placing the unit in direct sunshineor near a heating
appliance.
L
BE CAREFULOF MAGNETICFIELDS
DO NOT place a magnet, loud speaker system,floppy disk
drive, or anythingwhich will generate magnetismnear the unit.
A magneticfield may cause blurred
displayedpattern.
coloursor distortionof the
14MVXUser Manual3
@PERATD@
Controls
Front View
,,,
(7)(6)(5)(4)(3)(2)(i)
--J
(J)
1
Rear View
\
1
I
t
(8)
(1) Power Switch
Use this switch to power ON or OFF by pressing it.
When the power is ON, green light on the knob turns on to indicate.
(2) Contrast Control
Use this to set the foreground brightness of the screen.
(3) Brightness Control
Use this to set the background to black.
Most of the latest application software utilizes coloured background and this control
is usually set at its maximum.
(4) Horizontal Size
Adjust this control to the preferred horizontal width. If the width is too wide, part of
information will be missed from the screen.
(5) Horizontal Position
Adjust this to place the display at the centre of the screen.
4 14MVX User Manual
,,
(6) Vertical Size
Adjust this control to the preferred height.
(7) Vertical Position
Adjust this to place the display at the centre of the screen.
(8) Signal Cable
Connect the end of the cable to your computer.
(9) Power Cord In-let Connector
Insert proper power cord here.
BEFORE CONNECTINGTHE MONITORTO YOUR
COMPUTER,MAKE SURE THE POWER TO THE MONITOR
AND COMPUTERARE TURNED OFF.
1. Connect the signal cable to your computer’s video output connector. The comector is compatible with IBM PS/2 series computers and VGA standard graphics
cards for IBM PC, PC/XT, PC/AT, and compatibles.When you are using the
monitor with Apple Macintosh II computer, please obtain an optional converter for
connection from your dealer. Hitachi’s part number for convertec
2. Connect power cord to the monitor then to wall power outlet.
USE PROPERLY APPROVED POWER CORD...HO5VVHZF.
Se-l
3. Power on the monitor then power on your computer.When you switch OFF,
reverse the sequence.
4. Adjust front located user controls to obtain right picture size, location, and
brightness. Display location on the screen and the size may change when you switch
from one application software to another one.
5. Adjust Tilt& Swivel to suit your eye level.
.
DO NOT use the monitor with a bright backgroundlight, direct sunshine, or bright
light into the screen area. These may increase eye fatigue.
14MVXUser Manual 5
=14MVX is compatible with
1. IBM PS/2 series computers with MCCA, VGA and 85 14/A graphics standards.
Signal cable iscotilguredasIBM8514monitor.
2. Most of the VGA and Super VGA standard graphks boards available for the PC,
PC/AT and EISA bus computers.Please ask your dealer for details.
3. Apple Macintosh II computer with Macintosh Video Card. You have to obtain a
15 pinto 15 pin converter (Hitachi parts: SC-1 ) from your dealer.
Connector Pin Assignment
Pin#
1 Red Video
2 Green Video
3 Blue Video
4 Ground
5 Ground
6 Red Ground
7 Green Ground
8 Blue Ground
6 14MVXUser Manual
Ph#
9 No Pin
10 Ground
11 Ground
12 No Pm
13 Horizontal Sync
14 Vertical Sync
15 No Connection
(specifications’)
CRT14(1 3V) inches diagonal, 0.28 mm dot pitch, Black~
matrix, Silica coated, Short Persistence.
Input SignalVideo: 0.7 Vpp
Sync: Separate H,V or Composite H/V TTL level or
Sync on Green at 0.3 Vpp.
SynchronizationHorizontal: 30 — 40 kHz
Vertical
Automaticallysynchronize.
5O—1OOHZ
h
m
Resolution
Vidw Band Width
Active Display Area
MismnvergenceLess than 0.55 mm
Power Supply
Power Consumption80 W Approximately
Dimensions358 (W)
Weight15 kg
EnvironmentalOperation
ConditionsTemperature:5°C to 35°C
Horizontal: Up to 1024 dots
Vertical:Up to 768 lines (Interlaced) or 600 lines
(Non-interlaced)
45 MHz
Horizontal: 240 mm
Vertical:180 mm
Active d~play area is changed by the graphics board
standard.
AC 100--120V, 50/60 Hz/ 200--240V, 50 Hz
X 372 (H) X 403 (D) mm
Including Tilt & Swivel base.
Humidity:30% to 80%
Storage
-20°C to 60”C
10% to 90%
14MVXUser Manual7
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.