Hilti KWIK BOLT II INSTALLATION

163

US: 1-800-879-8000 / www.us.hilti.com ❘ Hilti Product Technical Guide 2002 ❘ Canada: 1-800-363-4458 / www.ca.hilti.com

Kwik Bolt II (Stud Version) Installation Instructions

Hilti Tamper Proof Nut (HTN) Installation Instructions

1. Hammer drill a hole the same

nominal diameter as the Hilti
Kwik Bolt II, with or without the
fixture in place—the Kwik Bolt
II works in a “bottomless” hole.

1. Hammer drill a hole the same
nominal diameter as the Hilti
Kwik Bolt II with or without the
fixture in place. Clean hole
with a blow out pump or
compressed air.

2. Put protective sleeve and
tamper proof nut on Kwik Bolt
II so impact section (dog point)
is exposed. Drive anchor far
enough into the hole so that at
least six threads are below the
top surface of the fixture.

3. Tighten the torque head with
ordinary wrench until nut
breaks away, leaving only
the free spinning sleeve and
tamper proof fastener.

4. Free turning protective sleeve
and tamper proof fastener
remain.

2. Clean hole with blow out bulb. 3. Drive the Hilti Kwik Bolt II far
enough into the hole so that at
least six threads are below the
top surface of the fixture, using
a Hilti 2 lb. hammer.

4. Tighten to the recommended
torque value with a torque
wrench, or if torque wrench is
not available, 2 or 3 turns from
the finger tight position to
achieve proper anchor setting.