Hilti HIT RE 500 User Manual
A
1
2
1
2
1
2
1
2
1
2
3
1
2
9
11
≤T
max
12
9
11
T
max
9
10
11
dhesive Anchoring Systems
4.2.6 HIT RE 500 Epoxy Adhesive Anchor
4.2.6.4 Installation Instructions
1. Drill anchor hole using carbide or
diamond core bits.
5. Screw on static mixer. 6. Put holder into dispenser and
2. Clean hole with a nylon or wire
brush. Proper hole cleaning is
essential. For core bits, flush hole
clean with water then immediately
remove standing water.
card the first three trigger pulls
of adhesive from each refill
pack.
Rod
Insert
dis-
3. Insert air nozzle to bottom of hole
and blow out hole using a pump,
or compressed air. For underwater
holes, flush hole with clean water
after brushing.
7. Inject adhesive into hole starting at
the bottom until 1/2 to 2/3 full.
Use mixer filler tube extensions
when needed to reach the hole
bottom.
4. Insert refill pack into holder.
Remove cap covering threaded
projection.
8. Unlock dispenser.
≤ T
max
Rebar
9. Insert rod, threaded insert or rebar.
Twist during installation.
172 Hilti, Inc. (US) 1-800-879-8000 | www
≤ T
max
10. Fastener may be adjusted during
specified gel time.
.us.hilti.com
I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www
11. Do not disturb anchor between
specified gel time and initial cure
time. At the initial cure time the
fastener has 25% of full working
load. Work may proceed (e.g.
tying rebar,setting steel) which will
not exceed 25% of the full working
load. Do not torque anchor.
12. After full cure time, apply specified torque as required to secure
items to be fastened. Do not
exceed maximum torque specified.
.ca.hilti.com
I Pr
oduct T
echnical Guide 2006
Loading...