Hestan GRCHS30 Installation manual
REFRESHMENT CENTER /
INSULATED SINK
Installation Instructions
GRC / GRCHS / GIS / GISHS / AGIB
IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN
INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER
Some parts have sharp edges. Care must be taken when handling the various components to avoid
personal injury. Wear gloves when handling. The unit is heavy and awkward to move around. Two
people should work together to lift the unit into the cutout in your island.
TOOLS REQUIRED:
Work gloves
Safety glasses
Phillips screwdriver
Flat-blade screwdriver
Level
Tape measure
Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper
and initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage. DO NOT
discard any packing material (box, pallet, straps) until the unit has been inspected.
EN
Remove all exterior packaging materials, banding, tape, etc. Remove all protective film from the inside of
your product. You may leave any exterior protective film on until after installation is complete.
CONFIGURATIONS
Your new Hestan Refreshment Center / Insulated Sink is offered in 4 different configurations, as well
as a separate Ice Bin accessory. Other accessories are available for purchase to further customize your
product. Please visit the Hestan website (www.hestanoutdoor.com), or contact your Hestan dealer for
more information.
GRC30 GRCHS30 GIS30 GISHS30 AGIB
©2017 Hestan Commercial Corporation
1
EN
INSTALLATION
1. Consult the end of this instruction manual to determine the appropriate cutout dimensions for your
product. The Hestan Refreshment Center / Insulated Sink is designed for outdoor use and features
corrosion-resistant stainless steel construction. The faucet (GRC & GRCHS models) is also made of
stainless steel and is outdoor-rated.
Some provision must be made in the island for fresh water supply and proper drainage of the sink. It is
recommended that the product be installed by a qualified technician or plumber in accordance with all
local building and plumbing codes.
As seen in this typical installation, Hestan Access Doors are mounted underneath the Refreshment
Center & Ice Bin to allow access to the plumbing underneath. This is not a requirement and your
professional outdoor equipment designer or installer may find another way to access this area.
2. Installation instructions for the faucet are packed in the carton with the faucet itself. It may be easier
to mount the faucet before installing the sink. The large 3-1/2” hole in the sink can accommodate
a standard basket strainer (not included), or a food-waste disposer (not included). Your qualified
technician or plumber should install this item before mounting the sink.
2
©2017 Hestan Commercial Corporation
INSTALLATION
MODEL GRCHS30 SHOWN
3. Carefully lower the sink into the cutout of your island countertop. Push the sink into position
and apply a small bead of clear silicone sealant around the perimeter of the outer frame to
your countertop. Your qualified technician or plumber may now assemble the water and drain
connections in accordance with local codes. In the absence of local codes, the Uniform Plumbing
Code should be followed.
4. Installation of the remaining components are detailed in the image below.
INSULATED ICE BIN
WITH SLIDING COVER
(continued)
EN
SPEED RAIL
CUTTING BOARD
©2017 Hestan Commercial Corporation
3
Loading...