Hertz ES 200.5 TECHNICAL SPECIFICATIONS

ES 200.5 600 W

Technical Specifications

Component Subwoofer
Size mm (in.) 200 (8)
Power handling W peak 600
cont. program 200
Impedance Ω 4
Frequency response Hz 30 ÷ 400
Sensitivity dB/SPL 88,5
Magnet size mm 120 x 60 x 34

D x d x h (in.) (4.7 x 2.35 x 1.34)

Total Driver l (cu.in) 0,82 (50)
Displacement

Voice Coil ∅ mm (in.) 50 (2)
Magnet High density ux ferrite
Cone
Weight of one kg (lb.) 3,7 (8.16)

component
*X-mech mm (in.) 13 (0.51)

*X-mech, maximum mechanical excursion: it indicates the
motion range in the speaker linear functioning area, in both ways.

Water repellent pressed paper

www.hertzaudiovideo.com

1. V-cone® technology with water-repellent paper membrane, for reduced
moving assembly mass and increased sensitivity.

2. Wide-wave spider prole, for high mechanical resistance against impulsive
stresses; its resin-bonded bre ensures consistent electro-acoustic
parameters in time.

3. High density foam surround, for extreme mechanical and acoustical linearity,
even under high excursion.

4. Copper voice coil wound on aluminium former, combined with the spider
support cooling system and bottom plate vent holes, for outstanding thermal
capacity in power peaks.

5. Silver plated silicone shielded lead wires ending with tin-plated, high
current terminals for high resistance against mechanical stress and low
contact resistance.

6. High magnetic permeability plates and large magnet, ensuring a constant
and even magnetic ux, for perfect low frequency control.

7. Butyl rubber gasket and magnet protective cover, provide ideal coupling to
the mounting surface, damping basket resonances.

Electro-Acoustic Parameters

D mm 165
Xmax mm 9
Re Ω 2,9
Fs Hz 40
Le mH 1,9
Vas l 10,5
Mms g 80
Cms mm/N 0,16
BL T·m 10,9
Qts - 0,5
Qes - 0,53
Qms - 10,57
Spl dB 88,5

A 216 mm 8.5 in.

B 181 mm 7.12 in.

C 121 mm 4.76 in.

D 106 mm 4.17 in.

Elettromedia - 62018 Potenza Picena (MC) Italy - T [phone] - F [phone] - www.elettromedia.it

All specications subject to change without notice_13.C