ITALIANO
DEUTSCH
ESPAÑOL
NEDERLANDS
ENGLISH FRANÇAIS
Русский
User Manual – 3/6
1.3. Recommended use
- Place the satellite speakers on a flat surface to prevent them from falling.
- Place the subwoofer directly on the floor (for example, below your desk) for better diffusion of
low frequencies.
- Do not open up your speaker kit under any circumstances, as doing so risks damaging the
internal components.
- This speaker kit is intended for use in a temperate environment.
- To avoid the risk of fire or electrical discharge, keep your speaker kit away from:
- rain or humidity, as well as all fluids (water, chemical products or any other liquids),
- heat sources such as radiators, stoves or any other heat-producing appliances (including
amplifiers),
- direct sunlight.
- Do not expose the speaker kit to drips or splashes of water.
- Never place any object filled with liquid (a glass, vase…) on the speaker kit.
- Unplug your subwoofer if you are not planning on using it again for an extended period of time.
Always hold the plug when unplugging the power cable; you should never pull on the cable
itself.
- Unplug the speakers’ power cord and disconnect them from your computer before cleaning. Do
not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
- Unplug the device’s power cord from an electrical outlet to power off the device. The power cord
must therefore remain easily accessible when plugged in.
- Attention: At full power, prolonged listening with headphones can result in damage to the user’s
hearing.
- Markings are located on the back of the speakers.
2. INSTALLING THE XPS 2.1 12 SPEAKER SYSTEM
2.1. Positioning the speakers
1. Place the satellite speakers on your desk on either side of the monitor, keeping them at least
50cm away from side walls.
2. Place the speakers at an equal distance from the listener and direct them towards the listening
position.
3. Place the subwoofer directly on the floor, taking care not to block the side opening up against a
wall.
Note: to determine the ideal placement for your speaker kit, try different positions in succession.
The closer you move the speakers to the wall, the higher the level of low frequencies will be.