Henny Penny MP-941, MP-942, MP-943, MP-944 Operation Manual

Model MP-941/942/943/944

SECTION 3. OPERATION

3-1. INTRODUCTION This section provides operating procedures for the

multipurpose holding cabinets. Read the Introduction,
Installation and Operation Sections, and all instructions
should be followed before operating the cabinet.

This section contains an explanation of all controls,
components, and information on operating procedures
and daily maintenance.

3-2. OPERATING Figure 3-1 identifies and describes the functions of all
CONTROLS AND the operating controls and components of the cabinet.
COMPONENTS

Item Description Function
No.

1 Digital Display An LED display which shows the time of day and drawer
temperature

2 LEDs When illuminated, setpoint temperature has been reached
3 UP and DOWN Used when programming the controls, changing the

Buttons display, and accessing the Special Program Mode
4 POWER Switch A rocker switch that controls the power to the unit
5 Drawer TEMP Used to view the drawer temperature, and to set the

Buttons setpoint temperature for the drawer
6 SET Button Used in the Program Mode

1210 3-1

3-2. OPERATING

CONTROLS AND

COMPONENTS (Continued)

3-3. START-UP

Model MP-941/942/943/944

Figure 3-1

Before using the cabinet, it should be thoroughly
cleaned as described in the cleaning procedures
section of this manual. To put the cabinet into
operation, move each POWER switch to the ON
position and adjust each control to the appropriate
temperature. The power light should illuminate
indicating that the unit is operating. The operating
temperature of this unit should be achieved in
approximately 30 minutes.

3-2 103