Henny Penny HHC-990 Installation Manual

Model HHC-990

SECTION 2. INSTALLATION

2-1. INTRODUCTION

Installation of this unit should be performed only by a
qualified service technician.

Do not puncture the skin of the unit with drills or
screws, or component damage or electrical shock
could result.

2-2. UNPACKING The Henny Penny humidified holding cabinet has been

tested, inspected, and expertly packed to ensure arrival
at its destination in the best possible condition.

Note any shipping damage in the presence of the
delivery agent and signed prior to his or her departure.

T o remove the Henny Penny cabinet from carton:

1. Carefully cut banding straps.

2. Lift carton off the unit.

3. Lift the unit off the cardboard padding and skid.

Full-size cabinets weigh approximately 300 lbs.
(136 kg). Care should be taken when lifting unit to
prevent personal injury .

303 2-1

Model HHC-990

2-2. UNP ACKING (Continued) 4. Open doors and remove packing from behind racks and

the water pan in the bottom of the unit.

5. Peel off any protective covering from the exterior of the
cabinet.

6. The cabinet is now ready for location and use.

2-3. LOCA TION Place the humidified holding cabinet in an area that allows

the doors to be opened without interference of loading and
unloading product. Also, keep the unit level for proper
operation.

No minimum clearances are required for the rear and
sides of the cabinet.

2-2 303