Henny Penny HHC-983 Operation Manual

SECTION 3. OPERATION

Model HHC-980/983

3-1. INTRODUCTION

This section provides operating procedures for the humidfied
holding cabinet. Read the Introduction, Installation, and
Operation Sections before operating the unit.

This section also contains explanations of all controls, along
with operating procedures and daily maintenance.

3-2. OPERA TING CONTROLS

3-1 1 Power Switch A rocker switch that sends electrical current to the operating

components when turned on.

3-1 2 T emperature LED Lights when the control calls for heat, and the unit should start

heating. It goes out once the temperature inside the cabinet
reaches the programmed temperature setting.

Press the T emperature Button to set the cabinet temperature.

3-1 3 Digital Display Shows the cabinet temperature, humidity settings, and the selec-

tions in the Program mode. The temperature of the cabinet
is shown by pressing the INFO button. If the temperature
exceeds 300 °F (149°C), the display reads “E-5”, TOO HOT”.

3-1 4 Humidity LED Lights when the control calls for humidity. It goes out once the

humidity inside the cabinet, reaches the programmed humidity
setting.

Press the Humidity button to set the relative humidity inside the
cabinet, and to choose between the Proofing and Holding modes,
when the unit is turned on.

3-1 5 Press the Info button to display the current cabinet humidity and

temperature, and time and date. Also, in the program mode, it
steps back to the previous parameter.

3-1 6 & 7 Are used to adjust the value of the currently displayed setting in

the Program mode.

8 This button is used to access the Program modes.

Also, once in the Program mode, it is used to advance
to the next parameter .

3-1 203

3-2. OPERATING CONTROLS
(Continued)

Control Decal

1 2 3 4 5 6 7 8

Model HHC-980/983

Figure 3-1

803 3-2