Henny Penny HDS-300 Installation Manual

Model HDS-300

SECTION 2. INSTALLATION

2-1. INTRODUCTION This section provides the installation instructions for the Henny

Penny Holding Display Station.

Installation of this unit should be performed only by a qualified
service technician.

Do not puncture the skin of the unit with drills or
screws as component damage or electrical shock
could result.

2-2. UNP ACKING The Henny Penny Holding Display Station has been tested,

inspected, and expertly packed to ensure arrival at its destination in
the best possible condition. The unit is shipped in 3 separate cartons
and have been bolted to a wooden skid. The units are then
packed inside a triple wall corrugated carton with sufficient padding
to withstand normal shipping treatment.

Any shipping damages should be noted in the presence of the
delivery agent and signed prior to his or her departure.

T o remove the Henny Penny Holding Display Station from the
carton, you should:

1. Carefully cut banding straps and remove units from packaging.

Be sure to keep the owners manual from the Randell refrigera­tion unit when unpacking the unit. Important warranty informa­tion is contained in the manual.

The data plate for the Randell refrigeration unit is located on the
mechanical base, by the compressor.

605 2-1

2-3. ASSEMBLY

Figure 1

Model HDS-300

Due to the size and weights of the refrigeration unit
and the top unit of the HDS-300, more than one person is
needed to lift the pieces into place, or personal injury
could result.

1. Using a Phillip’s head screwdriver , remove the screws securing
the rear panel of the cold well on the table, and remove panel.
Figure 1.

2. After the packaging has been removed from the refrigeration
unit, pull up on the 4 mounting brackets on the sides of the
refrigeration unit and remove the brackets. Figure 2.

Figure 2

Figure 3

3. Noting that the drain of the refrigeration unit goes towards the
hot well, carefully lift the refrigeration unit and place into the
open slot in the table top.

4. Pull the cord and plug through the hole in the top, rear shroud.

5. Reinstall the refrigeration brackets and secure the refrigeration
unit in place by tightening the bolts against the table top.
Figure 3.

6. Reinstall rear panel, removed in step 1.

7. Install the vented, stainless steel panel, supplied with the
refrigeration unit, to the front of the refrigeration unit. Figure 4.

Figure 4

2-2 605

2-3. ASSEMBLY (Continued)

Figure 5

Model HDS-300

8. Using silicone sealant (silicone or equivalent sealant must be
NSF listed material), seal the refrigeration unit to the table top.
Figure 5.

Figure 6

9. Carefully lift the top unit onto the table top, making sure the
french fry station element is over the french fry tray . Figure 6.

10. First, line up the 2 outside holes (circled), in the table top with
the holes in the end channels of the top unit, and secure the
units together using 2, 1/4-20 in these holes. Then screw
1/4-20 bolts in the remaining 4 holes. (total of 6 at each end.)
Figure 7.

Figure 7

1205 2-3