Henny Penny HCD-930 CDT Installation Manual
Model HCD-930/932 & HCD-930/932 CDT
SECTION 2. INSTALLATION
2-1. INTRODUCTION
Installation of this unit should be performed only by
qualified service personnel.
Do not puncture the skin of unit with drills or screws as
component damage or electrical shock could result.
2-2. UNPACKING The Henny Penny Heated Holding Cabinet has been inspected,
tested, and packed to ensure arrival in the best possible
condition. The cabinet is packed inside a triple wall carton
with sufficient packing material to withstand normal handling
in shipment. The carton is also strapped onto a wooden base.
Any shipping damages should be noted in the presence of
the delivery agent and signed prior to his or her departure.
To remove the cabinet from its carton:
1. Cut the bands holding the wooden base to the carton.
2. Lift the carton off the cabinet.
3. Remove unit from the wooden base.
4. Remove all packing material from around cabinet and
inside drawers.
5. Peel off protective covering from exterior of cabinet.
Your heated holding cabinet is now ready to be located and
installed.
2-3. LOCATION The unit should be placed on a table or shelf to allow
easy access for loading and unloading of product. For proper
operation, the cabinet must be level.
103 2-1
HCD-930/932 & HCD-930/932 CDT
2-4. ELECTRICAL The heated holding cabinet is available from the factory as a
CONNECTION
120 VAC, 50/60 Hz, or 230 VAC, 50 Hz, single-phase unit.
The data plate on the back of the unit specifies the correct
electrical supply. The unit requires a grounded receptacle with
a separate electrical line protected by a fuse or circuit breaker
of the proper rating.
To avoid electrical shock, the cabinet must be
adequately and safely grounded (earthed) according to
local electrical codes.
(FOR EQUIPMENT WITH CE MARK ONLY!)
To prevent electric shock hazard this appliance must be
bonded to other appliances or touchable metal surfaces
in close proximity to this appliance with an
equipotential bonding conductor. This appliance is
equipped with an equipotential lug for this purpose.
The equipotential lug is marked with the following
symbol
Model Number
Volts Watts Amps
HCD-930/932 120 846 7
HCD-930/932 230 846 3.6
2-5. PHYSICAL
SPECIFICATIONS
• 46 cm. wide x 64 cm. deep x 53 cm. high (18” x 24” x 21”)
• 46 cm. wide x 64 cm. deep x 42 cm. high (18” x 24” x 16”)
• HCD-930 – Shipping weight – 62.7 kg. (138 pounds)
• HCD-932 – Shipping weight – 60.7 kg. (134 pounds)
2-2 1004
Loading...