Henny Penny EPC-2 Installation Manual

Model EPC-2, EPC-3 & EPC-4

SECTION 2. INSTALLATION

2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny

heated express cabinet.

Installation of this unit should be performed only by a qualified
service technician.

Do not puncture the skin of the unit with drills or screws as
component damage or electrical shock could result.

2-2. UNP ACKING

The Henny Penny heated express cabinet has been tested, inspected,
and expertly packed to insure arrival at its destination in the best
possible condition. The unit has been bolted to wooden skid. All
items have been packed and taped inside of the unit. The unit is then
packed inside a triple wall corrugated carton with sufficient padding to
withstand normal shipping treatment.

Any shipping damages should be noted in the presence of the
delivery agent and signed prior to his or her departure.

T o remove the Henny Penny cabinet from the carton, you should:

1. Carefully cut banding straps.

2. Open flaps of carton and remove packing.

3. Remove carton from unit.

4. Remove unit from packaging.

707 2-1

Model EPC-2, EPC-3 & EPC-4

2-2. UNP ACKING

(Continued)

Figure 1

5. Unpack and install shelves.
a. Hook the shelf brackets in the slots in the back, interior of unit.
b. Pull the cover off the receptacles on the right side of the shelves.

Figure 1.

c. Line up the prongs on the plug with the holes in the receptacle,

and firmly push the plugs into the receptacle. Figure 1.

The plugs must fit firmly into the receptacles for the shelf
heaters to operate.

6. Remove the bottom inserts and pull cardboard packing from around
elements in bottom of unit.

To avoid fire, remove the 3 corrugated shipping supports
located beneath these inserts, all visible packing material, tape,
and the unpacking instructions, prior to operation.

7. Peel off any protective covering from the exterior of the cabinet.

T ake care when moving the cabinet to pr event personal
injury.

8. Once the shelves are installed, and the packing material removed,
the unit is ready for operation.

2-3. LOCA TION The unit should be placed in an area where the unit can be loaded and

unloaded easily . For proper operation, the cabinet must be level.

If the Henny Penny heated express cabinet does

not have casters, level
the unit and run a bead of silicone rubber (silicone or equivalent sealant
must be a NSF listed material) around the perimeter of the unit, sealing
it to the floor.

2-2 707

2-4. CABINET DIMENSIONS

Model EPC-2, EPC-3 & EPC-4

EPC-2

408 2-3