Henny Penny CW-216 Installation Manual
Model CW-216/CW-114
SECTION 2. INSTALLATION
2-1. INTRODUCTION This section provides the installation instructions for the Henny
Penny Display Counter W armer .
Installation of this unit should be performed only by a qualified
service technician.
Do not puncture the skin of the unit with drills or
screws as component damage or electrical shock
could result.
2-2. UNP ACKING The Henny Penny Display Counter W armer is tested, inspected,
and expertly packed to insure arrival at its destination in the best
possible condition. The cabinet has been bolted to a wooden skid.
All glass items have been packed in cartons and taped inside the
unit. The unit is then packed inside a triple wall corrugated carton
with sufficient padding to withstand normal shipping treatment.
Any shipping damages should be noted in presence of delivery
agent and signed prior to his or her departure.
T o remove the Henny Penny Display Counter W armer from the
carton, you should:
1. Carefully cut banding straps.
1105 2-1
2-2. UNP ACKING (Continued)
Step 2
Model CW-216/CW-114
2. Open top flaps and remove packing.
3. Lift carton off skid.
Step 3
Step 4
4. Remove four bolts from under skid.
2-2 203
Model CW-216/CW-114
2-3. LOCA TION Place the unit on a table, preferably with a cut-out opening below
the cabinet to allow easy service connections and serviceability .
When setting up the Henny Penny Display Counter W armer,
be sure to level the table.
The unit has built-in draining capabilities, but this becomes
ineffective when set on an unlevel table.
After the Henny Penny Display Counter W armer has been
leveled on the table, run a bead of silicone rubber (or equivalent
sealant) around the perimeter of the unit, sealing it to the table
top. You are now ready to make the electrical and drain
connections to the unit.
2-4. REMOVE CONTROL END 1. Remove the seven screws fastening the end panel to the
PANEL cabinet.
2. Slide bottom of end panel out first allowing top to drop
below shelf edge.
Step 2
203 2-3
Loading...