Page 1
Log Set Assembly: LOGS-750TRS-E
1
2
3
4
5
1
2
1
LOG NOTCHES
NOTCH FOR PILOT
FLAT AREA FOR LOG #4
Model: SL-750TRS-IPI-D, SL-750TRS-IPI-E
SL-750TRSFHHIPI
STEP 1.
CAUTION: Logs are fragile, handle with care.
Carefully remove the logs from the packaging.
1
2
LOG PLACEMENT
INSTRUCTIONS
3
4
5
LOG NOTCHES
STEP 2.
LOG #1 (SRV2117-701) Place log #1 on left fl at side of
the burner assembly. Pull the log forward and slide it to
the right until the notches under the log are in the burner
grooves.
FLAT AREA FOR LOG #4
Figure 1.
1
NOTCH FOR PILOT
STEP 3.
LOG #2 (SRV2120-702) Place log #2 on the grate bar
and push it back against refractory. The pilot should be
centered within the large notch on log #2.
Heat & Glo • LOGS-750TRS-E • 2120-945 • 3/11
Figure 2.
1
2
Page 2
1
2
3
4
2
1
2
3
5
3
4
1
NOTCH
NOTCH
2
STEP 4.
LOG #3 (SRV2120-703) Place log #3 on right fl at side of
burner assembly . The notch on the log should fi t over the
bar on the far right side of the grate. Push the log back
against the grate tab.
STEP 5.
LOG #4 (SRV2120-704) Place log #4 so that the right
end sits in the notch or fl at spot of log #2. The left end of
the log will sit on the left grate tine and also contact the
vertical portion of the grate tine as shown in Figure 4. The
“burned” part of the log should be pointed downward.
Figure 3.
Figure 4.
1
“BURNED” PORTION
POINTS DOWNWARD
4
1
NOTCH
NOTCH
2
3
3
STEP 6.
LOG #5 (SRV2117-705) Place log #5 on log #2. Log #5
will mate with the fl at areas located on the top side of Log
#4. See Figure 5.
Heat & Glo • LOGS-750TRS-E • 2120-945 • 3/11
Figure 5.
MATE WITH FLAT AREAS HERE
5
2
4
1
3
Loading...