Page 1
Log Set Assembly: LOGS-350TRS-D
Left rear log tab
Lava rock retainer
Grate tine (4)
1
Mate slot with tab
Left rear log tab
Groove used to locate log # 2
2
Mate log with tine
Mate log with groove on log # 1
Tip should touch log # 2
Figure 2
Figure 3
Figure 4
Figure 5
Right rear log tab
Shoulder screw
Swing branch towards burner
Groove used to locate log # 3
Log # 3 should rest on log # 1
Mate “Y” with groove
3
Models: SL-350TRS-D, SL350TRS-IPI
Note: Figure 1 illustrates the recommended gap between the
burner and the lava rock retainer.
Left rear log tab
Right rear log tab
LOG PLACEMENT INSTRUCTIONS
3/8 in.
Burner
Lava rock
retainer
No lava rock
may be placed
past this edge.
Figure 1
Left rear log tab
Groove used to locate log # 2
Shoulder screw
Lava rock retainer
Grate tine (4)
Figure 2
CAUTION: Logs are fragile. Log #1 (SRV2113-701): Locate the slot on the bottom right side of log 1. Mate the slot with the
right rear log tab. Pull the front left nose of log #1 forward until it touches the left rear log tab.
Mate log with groove on log # 1
Groove used to locate log # 3
2
Swing branch towards burner
Figure 3
3
1
Mate slot with tab
Tip should touch log # 2
Log # 3 should rest on log # 1
Mate log with tine
Figure 4
Log #2 (SRV2113-702): Locate the notch at the left end of
log # 2. Mate the notch with the tine as shown above. The
top end of log #4 should rest on the groove that is located
on the top of log #1. Swing the center branch toward the
burner (see above).
Heat & Glo • SL-350TRS-E Log instructions • 2113-935 Rev. D • 1/09 1
Mate “Y” with groove
Figure 5
Log #3 (SRV21 13-704): Locate the “Y” end of log # 3. Mate
the “Y” end with the groove on log # 2 (see above illustration).
Log # 3 should rest on log # 1, as shown above. The tip of
log #3 should touch log # 2.
Page 2
Figure 6
Mate shoulder screw with notch
Mate shoulder screw with notch
4
Mate groove and grate tine
Lava Rock
Figure 7
4
Mate groove and grate tine
Figure 6
Log #4 (SRV21 13-703): Locate the notch on the bottom of log # 4. Mate the notch with the shoulder screw that is located on the
burner top. Mate the rear groove with the far right grate tine as shown above. Apply the supplied lava rock as shown above.
Figure 7
Lava Rock
Heat & Glo • SL-350TRS-E Log instructions • 2113-935 Rev. D • 1/092
Loading...