Heat & Glo HEAT-ZONE-QFP Installation Instructions

TM

Installation

TM

Instructions

Models:
HEAT-ZONE-QFP
Air Duct Adapter Kit

This Heat-Zone-QFP Air Duct Adaptor Kit has been tested for use with QFP44. Check with your local building code agency
before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspec­tions. If you encounter any problems regarding code approvals, or if you need clarifi cation of any of the instructions con-
tained here, contact the Technical Services Dept., Hearth & Home Technologies Inc., 1445 North Highway, Colville, WA
99114, phone [phone].

Contents of Kit

• HEAT-ZONE-GAS Air Duct Kit

• Adaptor Cover Plate (4051-157)

• Heat Zone Adaptor (4051-034)

The adaptor cover plate and Heat Zone Adapter must be
installed on the QFP44 prior to installing the Heat-Zone-Gas
Air Duct Kit.

Installation:

• Remove the cover plate from the top of the fi replace and
discard it.

• Install the adaptor cover plate on top of the fi replace where
the original cover plate had been using the previously
removed screws.

• Using the adaptor cover plate as a guide, cut the insulation
and remove. See Figure 1.

Sharp Edges

• Wear protective gloves and safety
glasses during installation.

CAUTION

Top of Heat Zone Adaptor

Adaptor Cover Plate

Figure 1 Cutting the Insulation

• Install the Heat Zone adaptor by sliding into the hole of
the cover plate. See Figure 2. Line up the holes in the top
of the adaptor with the holes in the adapter cover plate.

• Attach the 6 in. round air duct from the Heat-Zone-Gas
Air Duct Kit to the top of the unit by lining up the holes in
the adaptor cover plate (Figure 1), the top of the adaptor
(Figure 2) and this duct. See Figure 3.

• Follow the installation instructions included with the HEA T­ZONE-GAS Air Duct Kit to complete installation.

Hearth & Home Technologies Inc. • HEAT-ZONE-QFP • 4051-328 Rev A • 08/06

Figure 2 Installing the Heat Zone Adaptor

Figure 3 Installing the Round Air Duct

1