Heat & Glo GFK-160T Installation Instructions

GFK-160T Fan System

CORD

FAN

TEMPERATURE

SENSOR

SWITCH

SPEED

CONTROL

CONTROL

NUT

CONTROL

KNOB

WIRE
LEAD

6’

WIRE
LEAD

GROMMET

6’

JUMPER

WIRE

- Installation and Operating Instructions -

Leave this manual with party responsible for use
and operation.

CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.

Note: For ease of installation install Fan Kit prior to
gas line installation.

1. Introduction

The GFK-160T Fan has been designed to circulate

room air through the replace to enhance heat output.

The GFK-160T fan system operates on 120 VAC, 60 Hz
power. This is available through a receptacle in the fac­tory installed junction box. The junction box is located in

the controls compartment of the replace.

A variable speed control is provided with the fan system

to provide quiet forced air ow at the desired speeds. A

temperature sensor switch, which automatically turns the
fan ON/OFF, is also provided with this kit. This kit may also
be installed for use with the optional IFT-RC400 remote
and auxiliary control module kit.

2. Kit Contents

Remove and verify contents from packaging before
beginning installation. See Figure 1.

3. Installation Precautions

The GFK-160T Fan Kit is tested and safe when installed in
accordance with this installation manual. It is your respon­sibility to read all instructions before starting installation and
to follow these instructions carefully during installation to as-

sure maximum benet from, and safe operation of, the fan.

This fan is carefully engineered and must be installed only

as specied. If you modify it or any of its components, you
may cause a re hazard and will void the WARRANTY. In

addition, such action may void the coverage provided by
the owner's home insurance.

NOTE: This fan kit is not approved for instal­lation with the use of the TWI-MOD decorative
barrier front.

CAUTION: All wiring should be done by a qualied electri­cian and shall be in compliance with local codes and with
the National Electric Code ANSI/NFPA NO. 70-current (in
the United States), or with the current CSA C22.1 Canadian

Electric Code (in Canada).

WARNING! Risk of Shock or Explosion! DO NOT wire

110V to the valve or to the appliance wall switch.

• Incorrect wiring will damage this valve.

• Incorrect wiring will override IPI safety lockout.

CAUTION! Do not install damaged components.

If any parts are missing or damaged, contact your dealer before
starting installation. DO NOT install a damaged kit.

Heat & Glo Lifestyle Collection • GFK-160T Instructions • 2087-023 Rev. F • 2/21

Figure 1 Components of Fan Kit

1

4. Installation Instructions

A. installing the Fan

Position the fan all the way to the left side of the replace

and center front to back. Pull the fan 1/8 inch to 1/4 inch

away from the side wall of the replace. See Figure 2.

Note: For wiring information see following pages.

B. installing the Fan

If the available IFT-RC400 IntelliFire Touch® Remote
Control & Auxiliary Control Module Kit is to be install to
control the fan, the temp sensor switch and speed sen­sor will be installed.

Proceed to Section 4.E.

Figure 2 Fan Location

2

1/8” TO 1/4”

FIREPLACE

WALL

BLOWER

Heat & Glo Lifestyle Collection • GFK-160T Instructions • 2087-023 Rev. F • 2/21