HBC radiomatic TF011 User Manual

TF0110__ integration manual

HBC

Author: Florian Abelein
Date: 08.06.2018

Seite 1 von 4
Revision: 0

1 Introduction ....................................................................................................................................... 1

2 Installation ......................................................................................................................................... 1

2.1 Possible Hosts ............................................................................................................................ 1

2.2 Installation process ..................................................................................................................... 1

3 Authorization requirements ............................................................................................................. 3

4 Labeling requirements for the host ................................................................................................ 3

5 RF exposure statement (mobile and fixed devices) ...................................................................... 3

6 RF exposure statement (portable devices) .................................................................................... 3

7 Instruction manual requirements .................................................................................................... 3

1 Introduction

This document describes the installation of TF0110__ into the HBC-transmitter.

2 Installation

2.1 Possible Hosts

The module TF011010 may be installed in every HBC-transmitter. It has to be supplied with a DC voltage of 3.0 V
up to 5V. The module TF011010 has an integrated RFID-antenna. So there is no need for an antenna installation.

2.2 Installation process

First of all the TF011010 module has to be put into the groove of the transmitter housing as the next picture shows.

TF0110__ integration manual

HBC

Author: Florian Abelein
Date: 08.06.2018

Seite 2 von 4
Revision: 0

As next step the connection cable has to be pushed into the TF011010 interface connector of the mainboard as the
next picture shows:

FCC

- The Federal Communications Commission (FCC) warns the users that changes or modifications to the unit
not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.

- FCC §15.105 (b):
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This euipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

Canada

- This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.

- Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de

licence. L’exploitation est autorisée aux deux conditions suivantes:

1) l’appareil ne doit pas produire de brouillage;

2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.