HBC radiomatic 5140007 Users Manual
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB Page 1 / 18
HBC – Radio Control
RRaaddiioo RReecceeiivveerr FFSSEE 55114
4
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifica tions subject to chan ge without notic e. 30-04-2003
Radio System
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 2 / 16 BE-514_I-V1-3-FCC.doc.DOC [ Word 2000 ] MB
Manufacturer: HBC-radiomatic GmbH
Haller Strasse 49 - 53
74564 Crailsheim • Germany
Tel. +49 ( 0 ) 79 51 – 3 93 - 0
Fax +49 ( 0 ) 79 51 – 3 93 – 50
E-mail: info@radiomatic.com
http://www.hbc-radiomatic.com
HBC radiomatic GmbH is not liable for any misprints or errors ! – All rights reserved.
™ radiomatic is a registered German trademark.
© 2003 – 04, HBC-radiomatic GmbH , D-74564 Crailsheim
No part of any software or of the present document may be reproduced in any manner whatsoever without
the expressed written permission of HBC-radiomatic GmbH.
Radio System
30-04-2003 Information and specifications subject to change without n otice.
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB Page 3 / 18
Table of Contents
1 Description
..................................................................................4
1.1 Unpacking and Examining the Consignment...............5
1.1.1 Transport Insurance............................................................5
2 Safety Instructions....................................................................6
2.1 Pictographs .....................................................................................6
2.2 General Safety Instructions...................................................7
2.3 Safety Instructions for Installation and Operation...8
2.4 FCC-Rules ...........................................................................................9
3 Installation and Mains Connection......................................10
Proper Installation of the FSE 514 Radio Receiver...............11
3.1 Radio Status Panel....................................................................12
3.2 Automatic HOLD Function Settings (Eltako)..............13
4 Fault Correction....................................................................... 14
5 Maintenance..............................................................................15
5.1 In The Event of a Fault ............................................................ 15
6 Technical Data..........................................................................16
6.1 Dimensions of the FSE 514 Radio Receiver............... 17
7 Certificates and Approvals................................................... 18
Appendix:
– System-specific Projections
– System-specific Circuit Diagrams and Output Wiring
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifica tions subject to chan ge without notic e. 30-04-2003
Radio System
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 4 / 16 BE-514_I-V1-3-FCC.doc.DOC [ Word 2000 ] MB
1 Description
The FSE 514 radio receiver is designed for the wireless reception of command
instructions for controlling light-w eight industr ial cranes and small hoists.
The FSE 514 radio receiver c an receive and pr ocess up to 14 control commands.
A non-interchangeable system addres s ensures the functional safety of the radio co ntrol
system when operating cranes or machines, This feature is particularly important when
several cranes or machines are in use, for example in halls and shops. The system
address is exclusively allocated to each HBC radio transmitter and its respective
receiver.
It is not possible to activate crane or machine functions using a radio control
system allocated to another crane or machine.
The radio receiver has general telecommunications approvals. It is not necessary to
have or to apply for a license to operate the receiver and the respective transmitter. The
radio receiver broadcasts in either a 30 cm or 70 cm bandwidth. The receiver is
equipped with < 5 mW or < 10 mW transmitting power .
Operating the radio receiver and transmitter using a different frequency range requires
the approval of the competent regula tive authorities for telecommunications.
High-quality radio technology pursuant to the guidelines laid down by the German
Regulative Authorities for Telecommunica tions and Postal Services and the Regulations
For The Prevention of Accidents combined with perfected microprocessor technology
guarantees the highest degree o f operative safe ty, service quality an d serviceable life .
Radio System
30-04-2003 Information and specifications subject to change without n otice.
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB Page 5 / 18
1.1 Unpacking and Examining the Consignment
When unpacking your radio con trol system ensure that the contents of the consignment
correspond with the specification on the delivery note.
As a rule, the complete radio control system 514 consists of the following parts and
components :
– 1 transmitter
– 1 transmitter carrying se t
– 2 rechargeable transmitter batter ies
– 1 battery charger
– 1 transmitter operating instruc tions
– 1 FSE 514 radio receiver with
– 4 rubber vibration dampers including hardware
– 1 receiver operating instructions
("Installation, Commissioning an d Operating Instructions")
To ensure that the radio control system arrives intact, HBC-radiomatic GmbH packs its
systems in reusable packaging ma terial.
We recommend storing all packaging materia ls in a safe place in case of la ter use.
1.1.1 Transport Insurance
When unpacking your radio control system check for possible transport damage !
Deliveries ex works Crailsheim are insured a gainst transport damage . Should any part or
component arrive damaged contact the carrier immediately (postal services, courier,
parcel service, forwarding agent), register complaint and have the damage inspected
and recorded. After having the reason for complaint recorded, assign the claim to the
manufacturer. You will find the necessary insurance forms together with the consignment
documents.
Note:
Failure to adhere to these instructions may render the transport insurance coverage
invalid.
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifica tions subject to chan ge without notic e. 30-04-2003
Radio System
Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 6 / 16 BE-514_I-V1-3-FCC.doc.DOC [ Word 2000 ] MB
2 Safety Instructions
2.1 Pictographs
The following pictographs will be used throughout the present operating instructions :
indicates shock hazard
Contacting components under voltage may lead to death. Housing marked with this
symbol may only be opened by qualified electricians after having disconnected the
device from the mains supply (supply voltage, operating voltage or input terminal
voltage).
indicates safety relevant passages
You will find this pictograph as an indicator for occupational safety measures. The
neglecting of such measures poses a serious hazard.
Always observe the instructions and be particularly attentive and careful.
Avoid any situations that could at any time be a danger to persons or machines.
indicates important information or instructions
This symbol brings your attention to important information or instructions on how to
secure a long serviceable life of the radio control system.
Pay attention to the comments and instructions given. Ignoring the information provided
may permanently impair the reliability and operability of the equipment.
Radio System
30-04-2003 Information and specifications subject to change without n otice.
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Loading...