Hauler Racks HKAS5-1 User Manual
ALUMINUM HEADKNOCKER ACCESSORY RACK
-
-
Package Contents:
PARTS
(1) SCREEN ASSEMBLY
(2) SCREEN ‘L’ MOUNTS
(2) LOWER SCREEN MOUNTS
Before you begin:
Remove all components from the shipping carton.
The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands securing
components together.
Read the instructions thoroughly to familiarize yourself with the assembly sequence.
Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for minor
adjustments to the rack during the installation process.
Gather the following tools used to assemble and install the rack.
9/16” Socket or open end wrench
1/2” Socket or open end wrench
Pencil or marker
Tape measure
HARDWARE KIT
(2) 3/8”-16 x 2-1/2” HEX BOLTS
(2) 3/8”-16 x 1-3/4” HEX BOLTS
(2) 3/8”-16 x 1” HEX BOLTS
(6) 3/8”-16 NUTS
(6) 3/8” SPLIT LOCK WASHERS
(2) 5/16”-18 x 1-1/2” HEX BOLTS
(2) 5/16”-18 NUTS
(2) 5/16” SPLIT LOCK WASHERS
(4) PLASTIC END CAPS
Page 1 of 5
HAULER RACKS, INC.
st
7109 31
Minneapolis, MN 55427-2848
WWW.HAULERRACKS.COM
Avenue North
Toll Free: 1-800-843-5445
Phone: 763-546-5620
Fax: 763-546-0933
1. Lower Brace assembly
Slide (1) 5/16”-18 x 1-1/2” bolt into the center channel of the lower screen brace. Place end caps on each end of the lower screen brace.
Repeat for other lower screen brace.
2. Lower Braces to Screen assembly
Align the 5/16”-18 x 1-1/2” bolt in the lower screen brace with the bolt hole on the bottom of the screen assembly.
Loosely secure with 5/16” split lock washer and 5/16”-18 nut. Repeat for other lower screen brace.
Page 2 of 5
HAULER RACKS, INC.
st
7109 31
Minneapolis, MN 55427-2848
WWW.HAULERRACKS.COM
Avenue North
Toll Free: 1-800-843-5445
Phone: 763-546-5620
Fax: 763-546-0933
Loading...