Hatco PMG-200 Parts List
POWERMITE
®
Gas Booster Heater
REPLACEMENT
PARTS LIST
PMG-60
PMGH-60
PMG-100
PMG-200
PMG Series
HATCO POWERMITE
®
PMG-60 GAS BOOSTER HEATER
CAUTION - Use of replacement parts other
than those supplied by Hatco Corporation
may result in damage to the unit or injury to
personnel.
Model Designation
PMG-XXH
P =Power
M=Mite
G=Gas
X =Input BTUs/Hour
(Approximate)
H =Hood
Form No. PMGRP-0705 2 Printed in U.S.A.
20
40
28
8
24A
39
30
41
25
29
27
5
10
13
4
3
2
9
A
B
16
15
14
32
19
22
35
34
21
23
37
36A
1
17
7
11
12
6
Model PMGH-60
24 Hour 7 Day Parts
& Service Assistance
available in the United
States and Canada by
calling (800) 558-0607.
Form No. PMGRP-0705 3 Printed in U.S.A.
1 Low Water Cut Off Board 120V R02.01.210.00 1
2 Relay 24VAC Relay DPDT 02.01.116.00 1
3 Socket for Mini Relay 02.01.125.00 1
4 Sectional T-Block Complete 02.15.027.00 1
5 Tank High Limit, Manual Reset 02.16.116.00 1
6 Control Thermostat with Probe R02.16.068.00 1
7 Temperature Control Probe R02.16.069.00 1
8 Flame Rollout High Limit/
Heat Exchanger High Limit 02.16.106.00 2
9 Transformer 120/24V (40VA) 02.17.034.00 1
10 Toggle Switch, On/Off R02.19.008A.00 1
11 Indicator Light, Green 120 Volt 02.19.070G.00 1
12 Indicator Light, Red 120 Volt 02.19.070R.00 1
13 Boot Cover, Toggle Switch 02.20.040.00 1
14 Pilot Spark Cable, High Voltage 02.21.019.00 1
15 Back Pressure Relief Valve (Optional) 03.02.039.00 1
16 Ignition Module R02.21.022.00 1
17 Natural Gas Combination Valve 02.21.023.00 1
18 LP Gas Combination Valve -
Conversion Kit* 02.21.024.00 1
19 Low Water Cut Off Probe 02.40.001.00 1
20 T/P Relief Valve 03.02.020.00 1
21 Manual Shut Off Valve 03.02.025.00 1
22 Pump Flange Kit with Bolts 03.05.026.00 1
23 Recirculating Pump R03.05.027.00 1
24A Flexible Water Lines† R03.05.049.00 2
PARTS COMMON TO ALL PMG-60 MODELS
24B Water Line Gasket* 05.06.066.00 4
25 NAT Gas Orifice #55 03.12.002.00 8
26 LP Gas Orifice #68* 03.12.003.00 8
27 Burner Blade Assembly R03.12.007.00 1
28 Heat Exchanger R03.12.008.00 1
29 Gas Manifold 03.12.009.00 1
30 NAT Gas Pilot Assembly with Orifice 03.12.010.00 1
31 LP Gas Pilot Conversion -
Orifice Only* 03.12.011.00 1
32 6" (152 mm) Plastic Legs 05.30.069.00 4
33 6" (152 mm) Stainless Legs* 05.30.070.00 4
34 Water Manifold
3/4" Assembly R03.04.004.00 1
35 Tempering Tank 01.05.003.00 1
36A Pressure Reducing Valve, Iron 03.02.004.00 1
36B Pressure Reducing Valve,
Brass* (Optional) 03.02.015.00 1
37 Temperature Pressure Gauge 03.01.003.00 2
38 LP Gas Conversion Kit,
(Includes LP Gas Valve,
Orifices and Pilot)* R00.02.0004.00 1
39 Water Treatment Canister
and Cartridge 03.05.061.00 1
40 Cartridge Only 03.05.061A.00 1
41 O-Ring Gasket 03.05.061B.00 1
ITEM DESCRIPTION PART NO. QTY.
ITEM DESCRIPTION PART NO. QTY.
A Blower Motor - 120 Volt 02.12.001.00 1
PARTS COMMON TO ALL PMGH-60 MODELS
ITEM DESCRIPTION PART NO. QTY.
B On/Off Rocker Switch 02.19.080.00 1
ITEM DESCRIPTION PART NO. QTY.
* Not Shown
Units manufactured in October 1999 or before use part number 04.01.013.00 for the replacement leg.
† Gasket should be replaced at each joint being serviced using Item #24B.
NOTE: Order Kit, Item 38, when converting units to LP gas.
NOTE: Consult factory if replacing Orifices or Burner Assembly to ensure proper sizing.
NOTE: When calling for parts/service, please supply altitude of installation location and fuel type.
Loading...