GPS 810EU/GPS 910EU
Quick-Start Guide
ENGLISH
Quick-Start Guide
Quick-Start Guide
2
Before You Begin
Before You Begin
4
2
Unlock Switch
Power On
3
1
Charge Battery
at Least 6 Hours
Go outdoors for at
Least 3 Minutes to
Obtain GPS Signal
Reception
What’s in the Box
What’s in the Box
WARNING: Operation of any feature of this
device while driving is dangerous. Do not
operate this device while driving. Do not view
or operate audio or video modes while driving.
For safety reasons,the GPS 810/GPS 910 will
cease navigation functions when the video
mode is enabled. Do not attempt to disable
any safety function incorporated in this device.
Any alteration of this device may cause serious
injury and shall void the warranty.
Temperatures below -10°C and above +55°C
should be avoided to prevent damage the unit.
Car Charger (12-24V)
Wall Charger (110-230V)
USB Cable
Quick-Start Guide
Carrying Case
Fold-Flat Mounting
Bracket
GPS unit.
Plastic Adhesive Disc
for Dash-Mount
Wireless Remote
Control with Battery
Mounting Disc for
Wireless Remote
Alcohol Cleaning Pads
for Mounting
Surfaces
To put the unit in stand by
mode, PRESS the power
button momentarily.
To turn unit completely o ,
PRESS and HOLD the power
button for 2 seconds.
Download the complete User’s Manual at www.guideandplay.eu
!
Quick-Start Guide
Quick-Start Guide
3
ENGLISH
Setup Wizard
Setup Wizard
Select Language
Select Units
Select Time Zone
Con rm Time of Day
1
2
3
C
4
The geographic information provided by
this device serves as a navigational aid
only and does not include information
pertaining to construction, road closures,
speed restrictions, road or tra c conditions,
or other circumstances relevant to public
safety. The driver must always be aware of
the actual road conditions and surroundings,
and decide whether or not to follow the
information provided by this device. Obey
all tra c laws and observe safe driving
practices. The manufacturer does not
accept responsibility for any inaccurate or
incomplete information provided by this
device.
!
Quick-Start Guide
Quick-Start Guide
4
2
1
Select Mounting Location
Se
In-Vehicle Installation
In-Vehicle Installation
2
Install the unit
in Mounting Base
3
1
!
Do not install this device in any manner that
impairs the safe operation of the vehicle. Do not
install this device on any airbag panels or in the
deployment eld of any airbags. Do not place
the device on the vehicle’s dashboard unsecured.
Failure to observe the installation or usage
instructions may result in tra c accidents or
personal injury.
The installation of this device on the windshield,
between the driver and the windshield, or
otherwise in any manner that obstructs
the driver’s clear view of the road or tra c
conditions is dangerous and may be prohibited
by law. In this case other mounting methods
should be used. Check your local laws before
mounting.
Please connect car charger to mounting base to
receive tra c messages (TMC). The FM antenna
required for TMC reception runs inside the car
charger cable.
Dash-Mount
Display
Angle
Adjustment
Windshield-Mount
Lock
Unlock
Clean dash with supplied alcohol pad.
Install
Mounting
Base
The GPS unit needs to be angled towards the
driver to allow proper operation of built-in
hands-free microphones.
Quick-Start Guide
5
ENGLISH
Use a coin to remove
the bottom cover.
Select Mounting Location
1
CR2032/DL2032
Install Battery
2
3
Push the knob down onto the base,
and turn clockwise to lock it into
place. The knob can be removed to
replace the battery by turning the
bottom counterclockwise.
Attach Control
Knob to Base
4
Orient the base so that the arrow is facing the front of the car.
You can either screw the base to the mounting location or use the
supplied adhesive pad.
If you use the adhesive pad, you must FIRST CLEAN the surface with
the supplied alcohol cleaning pad.
Toward front of car
Mount
Control
Knob Base
RightCenterLeft
Mounting the Control Knob*
Mounting the Control Knob*
Control Knob Button Operation
ter
Press once for Left button on screen.
Press and hold for 2 seconds to adjust
Volume Up/Down from outer ring
G
d
d
Press once for Right button
on screen.
Press and hold for 2 seconds
to adjust Brightness from
outer ring
Rotate outer ring to move the
highlight bar on the active screen
If
Left or Right button is held for
2 seconds, outer ring becomes
Volume or Brightness adjustment
Function screen dependent. Play next track
on music player or navigation screen.
uick-Sta
uick-Sta
“Press to select the highlighted
menu item.
Change map view on navigation
screen. Press and hold for
address con rmation or
alphabetical music and phone
book browsing.
Press once for Center
menu bar item
Press and hold for 2
seconds to suspend
power or turn on
* The control knob makes it easier to operate the unit. However, this is not a mandatory part of the installation.
Loading...