Harbor Freight Tools Low Profile Rear Spool Motorcycle Stand Product manual

Owner’s Manual & Safety Instructions

Save This Manual Keep this manual for the safety warnings and precautions, assembly,

operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.

Visit our website at: http://www.harborfreight.com

REV 14k

When unpacking, make sure that the product is intact

and undamaged. If any parts are missing or broken,

please call 1-888-866-5797 as soon as possible.

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product described herein.

Tools required for assembly and service may not be included.

Email our technical support at: productsupport@harborfreight.com

Read this material before using this product. Failure to do so can result in serious injury. SAVE THIS MANUAL.

Specifications

Maximum Weight Capacity 700 lb

Adjustable Width 10-1/2" min. to 14" max.

IMPORTANT SAFETY INFORMATION

Assembly Precautions

1. Assemble only according to these instructions. Improper assembly can create hazards.

2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.

3. Keep assembly area clean and well lit.

Use Precautions

1. This product is not a toy. Do not allow children to play with or near this item.

2. Use as intended only. Not for any aircraft purpose.

3. Inspect before every use; do not use if parts are loose or damaged.

4. The floor must be firm, level and in good repair. The floor must be strong enough to support the weight of the tool and the vehicle.

Assembly Instructions

4. Keep bystanders out of the area during assembly.

5. Do not assemble when tired or when under the influence of alcohol, drugs or medication.

6. Weight capacity and other product capabilities apply to properly and completely assembled product only.

5. Do not exceed listed weight capacity. Be aware of dynamic loading! Sudden load movement may briefly create excess load causing product failure.

6. Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product.

1. Loosely assemble the Bracket Covers (3) to the ends of each Support Arm (2) using the Bolts (11).

2. Insert the Square rods of the Left and Right Support Brackets (4, 5) into the Bracket Covers as shown in the assembly diagram.

3. Adjust the Left and Right Support Brackets to match the width of your motorcycle axle.

4. Tighten the Support Brackets firmly in place by tightening the Bolts (11).

Page 2 For technical questions, please call 1-888-866-5797. Item 99701

+ 2 hidden pages