Harbor Freight Tools Large Tilt Flat Panel TV Mount Product manual

Table of Contents

Safety ......................................................... 2

Specifications ............................................. 3

Installation .................................................. 4

SAFETY INSTALLATION PARTS LIST

Parts List and Diagram ............................... 7

Warranty ..................................................... 8

WARNING SYMBOLS AND DEFINITIONS

This is the safety alert symbol. It is used to alert you to potential

personal injury hazards. Obey all safety messages that

follow this symbol to avoid possible injury or death.

Indicates a hazardous situation which, if not avoided,

will result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury.

Addresses practices not related to personal injury.

Page 2 For technical questions, please call 1-888-866-5797. Item 61807

IMPORTANT SAFETY INFORMATION

Failure to heed these warnings may result in personal injury and/or property damage:

1. Do not exceed listed weight capacity. Be aware of
dynamic loading! Sudden load movement may

briefly create excess load causing product failure.

2. Do not mount Wall Bracket (1) to hollow wall,
gypsum board, or similar material that will
not support the weight of the TV. Mount only

to 2″ x 4″ wood stud or concrete/brick walls

that can safely support combined weight
of Wall Bracket, Support Arms, TV and all
attached hardware and components.

3. If unsure wall is strong enough to support
weight of TV and TV Wall Mount, contact a
professional installer to reinforce wall.

4. Do not mount overhead or to a non-vertical
surface. Mount parallel to the ground only.

5. Verify that mounting surface has no hidden
utility lines before drilling or driving screws.

6. Wear ANSI-approved safety goggles and
heavy-duty work gloves during installation.

7. Inspect before installing; do not mount to wall
if parts are missing, loose or damaged.

8. Assemble and install only according to
these instructions. Improper assembly and
installation can create hazards and lead to
personal injury and property damage.

9. Keep installation area clean and well lit.

10. Do not assemble or install when tired or when
under the influence of drugs or medication.

11. Weight capacity and other product capabilities apply
to properly and completely assembled product only.

12. Use as intended only. Do not use TV Wall Mount
for any purpose for which it was not designed.

13. This product is not a toy.
Do not allow children to play with or near this item.

14. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

15. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.

16. Carefully read TV instructions before

installation. Harbor Freight Tools is not
responsible for damage caused by failure to
follow TV mounting instructions, improper
installation, or improper/loose hardware.

SAFETYINSTALLATIONPARTS LIST

Specifications

SAVE THESE INSTRUCTIONS.

Weight Capacity 176 lb

TV Size Range 37″ to 70″ diagonal

200 x 200 mm, 300 x 200 mm

VESA Compliance

300 x 300 mm, 400 x 200 mm
400 x 300 mm, 400 x 400 mm
600 x 400 mm, 800 x 400 mm

Page 3For technical questions, please call 1-888-866-5797.Item 61807