Harbor Freight Tools 96252 Owner's Manual

ITEM 96252 24”

To prevent serious injury:

Wear ANSI-approved safety goggles during use.1.
Never use on live electrical circuits.2.

Keep ngers clear of sharp blades.3.
Keep out of children’s reach.4.

BOLT/CABLE WIRE MULTICUTTER

JAW GAP ADJUSTMENT INSTRUCTIONS

Jaw Gap Adjustment Cam-bolts
When properly set, the gap between the edges should be parallel
and be able to grip a sheet of paper. Observe the indexing arrows
bolt faces and turn them equally. Hold each bolt then tighten the nut.
Open and close the jaws a few times to set in the tool, and double
check the gap. Repeat the setting if jaw gap is incorrect.

Turn Cam-bolt arrows inward to close in jaw tips.
Turn Cam-bolt arrows outward to close in the jaw heels.

Jaws Lower Pivot Bolts

Over tightening of these bolts may intervene with smooth pivoting
action of the jaws.

Minimum Jaw Closure Limiting Screw

With the jaw gap set, back off the screw until it rests against the
opposite handle’s face, then unscrew it one more at and tighten the

nut.

Note: The Cam-bolts are pre-lubricated at the time of assembly. However, whenever the jaws
are re-adjusted, it is recommended to back off the Cam-lock nuts and place a drop of lubricating
oil inside the Cam-lock housing.

WARNING

Distributed exclusively by Harobr Freight Tools®.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our website at: http://www.harborfreight.com

Read this material before using this product. Failure to do so can result

in serious injury. SAVE THESE INSTRUCTIONS.

Copyright© 2009 by Harbor Freight Tools®. All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape
or form without the express written consent of Harbor Freight Tools.

For technical questions or replacement parts, please call 1-800-444-3353.