Harbor Freight Tools 95974 User Manual

L.E.D. TRAILER LIGHT KIT

Model

95974

®

ASSEMBLY AND OPERATION INSTRUCTIONS

Due to continuing improvements, actual product may differ slightly from the product described herein.

TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND

Copyright© 2007 by Harbor Freight Tools®. All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape
or form without the express written consent of Harbor Freight Tools.

For technical questions or replacement parts, please call 1-800-444-3353.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our website at: http://www.harborfreight.com

ALL WARNINGS AND INSTRUCTIONS BEFORE USE.

SPECIFICATIONS

Power Source 12 VDC only (Negative Ground Only)

2 combination stop, tail, turn signals, two amber side
marker lights, license plate light, and 23 ft. split Y-style
harness.

Light Type

Clearance

Weight 2.6 Pounds

16 LED’s per light
(12 rear facing large LED’s)
(4 small LED’s - on-side marker)
(Exception: LH light has 20 LED’s that include 4 white
LED’s facing down for plate illumination)

Meets all DOT and Federal Vehicle Safety (FMVSS)
requirements when installed properly.

Save This Manual

You will need this manual for the safety warnings and precautions, assembly, operat­ing, inspection, maintenance and cleaning procedures, parts list and assembly diagram.
Keep your invoice with this manual. Write the invoice number on the inside of the front
cover. Write the product’s serial number in the back of the manual near the assembly
diagram, or write month and year of purchase if product has no number. Keep this manual
and invoice in a safe and dry place for future reference.

GENERAL SAFETY RULES

WARNING!

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below may result in electric shock,

fire, and/or serious injury.

SAVE THESE INSTRUCTIONS

Stay alert. Watch what you are doing and use common sense when operating. Do

1.

not install Lights while tired or under the influence of drugs, alcohol, or medication. A

moment of inattention during installation may result in serious personal injury and/or

property damage.

Keep bystanders and children away while installing Light Kit.

2.

Use safety equipment. Always wear ANSI approved eye protection. Dust mask,

3.

nonskid safety shoes, hard hat, or hearing protection must be used for appropriate

conditions.

Use the correct lights and electrical set-up for your trailer. If your trailer, camper,

4.

etc. is OVER 80” wide, you will need to install three additional Red Marker Lights

(not included) onto the rear of the unit in order to comply with DOT standards. To do

so, mount the three Red Marker Lights to the rear of the unit, making sure the Lights

For technical questions, please call 1-800-444-3353.

Page 2SKU 95974