Harbor Freight Tools 61791 Product manual

SPECIFICATIONS

Bending Capacity

Mounting Hardware

90° Bends in 30” Wide
Stock x 17 Gauge Steel

Requires Four 3/8”
Diameter Bolts, Nuts and
Flat Washers (not supplied)

IMPORTANT SAFETY INFORMATION

1. Do not exceed maximum bend capacity of 30” wide stock or 17 gauge steel.

2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.

3. Keep ngers clear of Support Plate (5) and Moving Plate (6) during use.

4. Assemble only according to these instructions. Improper assembly can create hazards.

5. Mount only to at, stable bench top able to support weight of Bending Brake, item being bent, and
the bending force.

6. Verify that installation surface has no hidden utility lines before drilling the bolts.

7. Keep assembly and work area clean and well lit.

8. Keep bystanders out of the area during assembly and use.

9. Do not assemble when tired or when under the inuence of drugs, alcohol or medication.

10. This product is not a toy. Do not allow children to play with or near this item.

11. Use as intended only.

12. Inspect before every use; do not use if parts are loose or damaged.

13. Maintain product labels and nameplates. These carry important safety information. If unreadable
or missing, contact Harbor Freight Tools for a replacement.

ITEM 61791 For technical questions, please call 1-888-866-5797. Page 2