HWD1270TVE ME
AUTOMATIC DRUM WASHING MACHINE
USER MANUAL
HW-D1270TVE
HW–D1270TVE ME
HW-D1470TVE
HW–D1470TVE ME
pre-
WashRinse SpinDry
RinseSpinWash
wash
Delay
Extra
Dry EcoTime Start/
Rinse
Delay Extra
rinse
rinse
hold
Power
ON
Temp
Silk
OFF
Sport
Quickwash
Speed
Quick Wash
Wool
Rinse
Synthetics
Eco Start/
Pause
Pause
Spin
Cotton&Linen
Drain
Prewash
01 - 07 08 - 1
3
8
14 - 1
TABLE OF CONTENTS
BEFORE USE USING THE APPLIANCE MAINTENANCE
COMPONENTS> .............................. 3
PREPARATION> ............................... 4
SAFETY INSTRUCTIONS> .................. 5
INSTALLATION> ............................... 6
CONTROL PANEL> ........................... 8
LEGEND
Yes
No
Optional
For your safety, any instructions in this manual with this "Warning" sign must
be followed strictly.
PROGRAM SELECTION> .................. 10
CONSUMPTION AND TECHNICAL DATA> ...11
WASHING METHODS> ................... 12
CLEANING & CARE> ....................... 16
DISPLAY CODES> .......................... 18
TROUBLESHOOTING> ..................... 19
DISPOSAL
As a responsible retailer we care about the environment. As such we urge you to follow the correct disposal
procedure for your product and packaging materials.
This will help conserve natural recourses and ensure that it is recycled in a manner that protects health and
the environment.
You must dispose of this product and its packaging according to local laws and regulations. Because this
product contains electronic components, the product and its accessories must be disposed of separately from
household waste when the product reaches its end of life.
Contact your local authority to learn about disposal and recycling. The product and packaging should be taken
to your local collection point for recycling. Some collection points accept products free of charge.
We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur
as a resultof product improvement and development.
BEFORE US
E
COMPONENTS
Please read these instructions carefully before using this appliance. The instructions contain important information which will help you
get the best out of the appliance and ensure safe and proper installation, use and maintenance.
Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance.
If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so that the
new owner can become familiar with the appliance and safety warnings.
ACCESSORIES
Check the accessories and literature in accordance with this list:
1x Inlet hose assembly
AUTOMATIC DRUM WASHING MACHINE
HW–C1470TVE
HW–C1270TVE
HW–C1070TVE
HW–C870TVE
1x User manual 1x Drain hose bracket
USER MANUAL
HW–C1470TVE ME
HW–C1270TVE ME
HW–C1070TVE ME
HW–C870TVE ME
pre-
ON
RinseSpin
Wash
wash
OFF
Rines
DelayExtra
EcoTimeS
rinse
P
hold
1x Bottom cover
3x Blanking plugs
BEFORE USE
PREPARATION
PREPARING THE MACHINE
Remove all the packing materials to prevent unsteadiness, including the polystyrene base. Upon
opening the package, water drops may be seen on the plastic bag and the porthole. This is normal
phenomenon resulting from water tests in the factory.
DESCRIPTION
This diagram may be slightly different from the layout of the washing machine you have just
purchased due to technical improvements.
Power switch
Door handle
Work Top
Washer door
Control Panel
Detergent distribution drawer
Filter cover
pre-
WashRinse Spin Dr y
wash
Delay
Delay Extra
Drain hose
Water inlet valve
Power cord
Back cover
Back cover screws
Transportation bolts
Power
Temp
RinseSpinWash
Speed
Extra
Dry EcoTime Start/
Rinse
Eco Start/
rinse
Pause
rinse
Pause
hold
ON
Silk
OFF
Sport
Quickwash
Quick Wash
Wool
Rinse
Synthetics
Spin
Cotton&Linen
Drain
Prewash
T2
S1
T1
S2
T3
S3
BEFORE US
E
SAFETY INSTRUCTIONS
BEFORE SWITCHING THE APPLIANCE ON FOR THE FIRST TIME
5
DO ...
... make sure that the transport bolt are removed.
... Use a separate earthed socket for the power supply.
... Make sure that the plug is accessible.
... Hold the plug and not the electric cable when unplug-
ging the power supply.
... Make sure that the fuses in the power circuit are rated
for 15A.
... Keep away from heat sources and direct sun light to
prevent plastic and rubber components from aging.
... Make sure that the power cord is not caught under or
in the appliance and avoid damage to the power cable.
... Check that hose joints and connections are fi rm and no
water can leak. If joints are loose or there is leakage, turn off the
water supply and repair. Do not use the washing machine until
the hoses are properly fi xed.
DURING DAILY USE OF THE APPLIANCE
DO ...
... Pull up zips and fi x loose threads to prevent the items
from being entangled. If necessary, put small items into a net bag
or pillow.
... Turn off the machine after each wash program and switch
it off at the mains to save electricity and for safety. Wipe clean
the lower part of the porthole.
... Keep the door slightly open when the washing machine is
not in use to prevent formation of odours.
... Let the power cord be replaced by the manufacturer, his
service agent or other accordingly qualifi ed persons, in case it is
damaged.
... Ensure that the appliance is not used by persons with reduced physical, sensory or mental capabilities, lack of experience
and knowledge without supervision or instruction by a person
responsible for their safety.
... Supervise children to ensure that they do not play with
the appliance.
DO NOT ...
... Touch or use the appliance when barefoot or with wet
or damp hands or feet.
... Use fl ammable detergent or dry cleaning agent.
... Use any fl ammable sprays in close vicinity to the appli-
ance.
... Remove or insert the plug in the presence of fl ammable
gas.
... Allow children or infi rm persons to play with the appliance
or packing materials.
... Install the appliance outdoors in a damp place, or in an
area which may be prone to water leaks such as under or near a
sink unit. In the event of a water leak allow the machine to dry
naturally.
... Place the washing machine directly on a carpet, or close
to a wall or furniture.
DO NOT ...
... Touch the washer door during the washing process - it
gets hot!
...Place heavy objects or sources of heat or damp on top
of the appliance.
... Hot wash foam rubber or sponge-like materials.
... Open the detergent distribution drawer during the wash
cycle.
... Force the washer door open. The door is fi tted with a
self-lock device and will open shortly after the washing procedure
is ended.
... Open the washer door if the water level is visibly over
the porthole.
... Cover the washing machine with plastic cover so that
inside dampness cannot be kept in.
BEFORE USE
INSTALLATION
ADJUSTING THE BOTTOM COVER
When open the shrink package,you will fi nd a calcium plastic board
which is laid on the top of washing machine as shown in fi g.1.The board
is used for reducing noise by pasting it under the cabinet when setting
as shown in fi g.2
It keeps out the dampness and reduces the noise.
DISMANTLE THE TRANSPORTATION BOLTS
The transportation bolts are designed for clamping anti-vibration
components inside of the washing machine during the transportation
process.
Remove the back cover.1.
Remove the three bolts on the rear side and take out the synthetic 2.
stabilisers from within the machine.
Replace the back cover.3.
Fill the holes left by the bolts with blanking plugs.4.
Note:
1.When you replace the back cover,the convexity must
face to outside, and you
have to insert the back cover from the two gaps as shown
in fi g.3.
2.Keep the transportation bolts and synthetic stabilisers in
a safe place for later use.
1.
3.
2.
4.
fig.3
Adjusting the washing machine
There are adjustable feet under the bottom of the washing machine. Before use, they should be
adjusted so that the machine is level. This will minimise vibrations and thus noise during use. It will
also reduce wear and tear. We recommend using a spirit level to level the appliance.
Loading...