Haier HTC-60H, HTCD-160 Operation Manual
Solar Vaccine Refrigerator
Operation Manual
Model:
HTC-60H
HTCD-160
Read carefully the manual before use
The company reserves the right to interpret the manual
Appearance of product in kind prevails
Keep the manual along with invoice after reading in a proper manner
Product may be subject to technical or software upgrading without further notice
With high quality,
Haier deserves your choice.
The product is applicable to pharmacies, pharmaceutical factories, quarantine stations, health
centers and hospitals, used to store biological products and those need to be stored at a
temperature between 2~8°C.
Temperature
control
Safety
system
Refrigeration
system
Computer control, digital display of temperature, temperature display
accuracy as 0.1°C and temperature range as 2°C ~ 8°C.
High and low temperature alarm or sensor fault alarm
Two alarm methods (buzzing alarm, flashing alarm)
Refrigeration system with further optimization, imported compressor
and main components and better refrigeration performance
Sealing-pipe cold conduction patented technology and more uniform
temperature within the box
User-friendly design, computer control, smart and carefree,
adjustment not required
User-friendly
design
We apologize that the Haier solar energy product provided for you may be a little different from the
figure in the manual due to product improvement. The manual may be subject to changes without
further notice.
High-performance thermal insulation layer, with excellent insulation
effect
Automatic evaporation of condensate water, safety door latch
Equipped with USB charge jack, it can be used to charge devices
such as cellphones.
1
Content:
Product Feature....................................................................
Content.................................................................................
Safety Precautions...............................................................
Precautions for Use..............................................................
Product Installation...............................................................
Component Names..............................................................
Application method..............................................................
Cleaning and Maintenance..................................................
Circuit Diagram....................................................................
Specification........................................................................
1
2
3
5
6
13
16
19
22
24
2
Safety Precautions
Dear Haier User:
Thanks for using Haier solar product. In order to use the product better, please make sure to read
safety notes in this manual carefully.
Don’t
The solar panel shall be equipped with a lightning conductor;
The ground wire of the solar panel shall not be connected with the product.
Please use the special power supply labeled on the nameplate of the product. Otherwise,
the product might be damaged.
If you do not use the product for a long time, please pull out of the power plug, so as to
prevent from electric shock, electric leakage or fire of the power line for aging.
If you need a longer line for connecting the solar panel and the product, please refer to
instructions in the manual for the line specification.
If the product is idle for a long time in the area supervised by nobody, please ensure
keeping children far away from the product and also closing the door of the product
completely.
The product shall be installed by certificated operators or after-sales service personnel only.
Otherwise, fire might take place and the product might be damaged.
Does
The product shall be scrapped by relevant specified personnel only. The door shall be
disassembled to avoid accidents, e.g. suffocation.
When the product with an auxiliary battery is not in use for a long time, the battery cable
plug shall be pulled out.
Make sure that the product is placed on the flat floor. Otherwise, damage or injury or
abnormal noise might be caused due to the inclination of the product.
If toxic, harmful and radioactive substances are stored, please use the product in a safe
area. Improper use may endanger people’s health or the environment.
If inflammable gas leaks, please switch off the gas leakage valve immediately, open the
door and windows for ventilation and also do not move the switch or connector of the
product.
Please make sure that the product is switched off to prevent from damage to the product
before the product is maintained.
Make sure that surrounding drugs or suspended substances will not be absorbed into the
machine during maintenance. Otherwise, it is harmful to health.
After the product is moved, keep it silent for 10min. and do not switch it on immediately.
Otherwise, the refrigerating system might be damaged.
3
Please hold the door handle to close the door cover of the product to prevent from finger
injury.
Do not connect the product to the ground via coal gas pipeline, water supply pipeline,
telephone line or lightning rod. Otherwise, electric shock or other dangers might be caused.
It is strictly forbidden to connect the cathode and anode of the storage battery in the wrong
way, if the product is equipped with an auxiliary battery.
It is strictly forbidden to connect the cathode and anode of the solar panel in the wrong way.
Do not use the refrigerator in the open air. When the refrigerator suffers rain, electric
leakage might be caused.
Do not put the refrigerator in the wet place or the place where water may spray on it easily.
Otherwise, electric leakage or electric shock might be caused by lower insulation.
It’s forbidden to pour water on the refrigerator directly. Otherwise, electric leakage or
electric shock might be caused.
The solar panel shall not be installed on a high building, tree or other places where the
solar panel might be sheltered. Otherwise, the efficiency of the solar panel might be
affected.
It is forbidden to place inflammable or explosive or volatile substances in this product. The
product shall be far away from combustible sprays. Otherwise, explosion or fire might be
caused.
It's forbidden to place corrosive substances, e.g. acid and alkali, on the product directly.
Otherwise, its components or electric parts might be damaged.
It’s forbidden to drill a hole on the product without approval. Otherwise, the moisturizing and
refrigerating performance of the product might be affected.
It is forbidden to insert metallic goods, e.g. irony needle or wire, in any hole or gap of the
product. Otherwise, damage or injury might be caused when they touch moving parts.
It’s forbidden to pour water on the product directly. Otherwise, short circuit might be caused.
The user shall not disassemble, repair or refit the product. The certificated operator is
allowed to do this only. Otherwise, fire might be caused or the product might be damaged
because of improper operation.
Do not climb up the product or overlap the product. Otherwise, the product inclination might
injure people.
If the product is equipped with a freezing compartment, please do not put glass bottles and
charged substances in the compartment. Otherwise, they might get frozen and crack and
injure people.
Plastic package bags shall be put in the place where children cannot reach, because they
might choke children.
4
Precautions for Use
• For product with batteries, disconnect the switch of battery connecting lines if the product will be
out of service for long time. Reconnect the battery switch when it is put into operation again.
• Make sure the temperature inside the product has reached the set value and then put into the
articles.
• The temperature display value of product refers to the temperature value at the temperature
sensing probe inside the product. Though the temperature displayed is different from the actual
one at the center of product, it will approach to the real temperature gradually.
• Clean the product with neutral detergent diluted. Brushes, acids, gasoline, soap powders,
polishing powders or hot water are prohibited to clean product as these materials may damage the
painting surface and plastic & rubber components and parts. Never wipe the plastic & rubber
components and parts with volatile solvent such as gasoline.
• Shut off the power as well as the battery switch if the product will be out-of-service for a long time.
• Reduce the time of keeping door open when storing or taking food each time, to prevent great
fluctuation to the temperature and humidity inside the product.
• The product will see a sharp temperature increase in a short time when the door is opened, which
is normal, and the temperature will resume 1h after the door is closed.
• The product shall operate at an ambient temperature between +5°C and +43°C and the
temperature of vaccine storage area will exceed +2 to +8°C if the ambient temperature is below
or above defined one.
• Do not place articles at the bottom of inner container or around the shelf as the product
temperature will be ununiform if the air duct is blocked.
• The display temperature and humidity may be a little different from the actual ones due to
refrigeration inertia, which is normal.
• The USB 2.0 jack can only be used to charge devices that meet the above parameters; please
try to use it under conditions where there's sufficient sunlight.
5
Product Installation
Installation environment
Ambient temperature: 5°C to 43°C, air conditioning system is required as necessary.
Ambient humidity: below 85%Rh.
Avoid excessive dust.
Avoid mechanical swing or vibration.
The product shall operate at an altitude lower than 2000m.
Normal operation will be impossible for product if it is installed in environments
Caution
other than those described above as it is sensitive to ambient temperature. Start
operation after the environment is improved.
It is prohibited to install the product outdoor. Electric leakage or shock may be
caused if the product gets wet by rainwater.
The product shall not operate at places where ambient temperature is below +5°C.
Installation site
The installation site shall meet following requirements for normal operation and best performance of
product:
Do not install the product in a narrow and confined space and the door of the installation space
may not be smaller or lower than the product, to ensure smooth entry and exit of the product as
well as to prevent damage to the stored articles due to not timely repair of product as the
installation site is not easy to be accessed.
The ground at the installation site shall be solid and flat. It is well ventilated and free from direct
sunshine.
No smaller than 1m³ room shall be provided every 8g R600a to prevent refrigeration medium
from forming flammable mixed gas after accidental leakage.
Warning
Do not ground the product through gas pipes, water supply pipes, telephone
lines or lightning conductors as electric shock may be caused.
The power line or plug must be accessed after installation to ensure the power
can be disconnected in a timely manner in emergency cases. The air vent shall
be free from barriers.
6
Preparation Before Use
1.Remove the packaging materials and strings
Remove all packaging materials and strings for
transport.
Caution
2.Count refrigerator accessories accompanied
Check the articles inside the refrigerator against
the packing list; if any difference, contact the
after-sale service.
3.Placing conditions
Leave a gap of 10cm in minimum around the
refrigerator for ventilation and heat dissipation.
Caution
The plastic packaging bags shall
be out of reach of children.
Enough room shall be left at
the cabin grid for maintenance
and ventilation.
4.Adjust bracing foot (if included)
Rotate the leveling feet with wrench in
clockwise direction to extend them outward
and support on the ground. Make sure the
refrigerator will not move during operation.
Downward upward
Supporting foot
5.Standing
Do not switch on the power after the refrigerator is placed, leveled and cleaned. Keep it in
standing for more than 24h before switching on the power so as to ensure proper operation of
refrigerator.
7
6.Cable Selection
Please refer to the table below for the selection of appropriate cable diameter and length if necessary.
24VDC
Specification
Cross
Section
(mm²)[ Gauge]
41 1
69
88
10 7
7.Solar Panel Cable Connection
Direct connection of solar panel cable and product end cable
AWG
Maximum Length
(m)
10 32
15 49
20 65
25 82
(Inch)
12VDC(Applicable for HTC-60H only)
Cross
Section
(mm²)[ Gauge]
41 1
69
88
10 7
Specification
Maximum Length
AWG
(m) (Inch)
15 49
22 72
30 98
40 130
HTC-60H Product end cableH TCD-160 Product end cable
8.Door Handle Installation (for vertical products)
For a vertical product, the door handle shall be installed later according to the following
procedures:
1
1.Put the
handle end
face with a
hole down.
2
2.Align the
handle and
the handle
seat on the
door.
3
3.Lift the
handle upwards
after fixing the
handle with its
seat firmly.
8
4
4.Use screws to
fix the handle
firmly after
mounting the
handle firmly.
Loading...