Haier HHX7130 User Manual

Range Hood

Extractor de Aire

Hotte de Cuisiniere

User Manual Model

HHX7130

Guide de l’Utilisateur

HHX7130

Manual del Usuario Modelo

HHX7130

Quality Innovation Style

Cod:0103072334

English

SAFETY PRECAUTIONS

Warning! To reduce the risk of ﬁre, electric shock, or injury to persons, always exercise basic safety precautions, including the following:

1. Read all instructions before using the appliance.

2. Use this appliance only for its intended purpose as described in this user manual.

3. Do not use any accessories not recommended by the manufacturer.

4. This unit must be grounded.

5. Do not use this appliance for commercial uses.

6. Installation work and electrical wiring must be done by qualiﬁed technicians in accordance with all applicable codes and standards, including ﬁre-rated construction.

7. Sufﬁcient air is needed for proper exhausting of gases of fuel-burning equipment through the ﬂue (chimney) to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code authorities.

8. When replacing an existing range hood with your new Haier Range Hood, turn OFF the electrical power to the existing unit before removal.

9. Before servicing or cleaning the unit, turn the power OFF at the service panel and if possible, lock the service panel to prevent power from being switched on accidentally. If the service panel cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

10. Do not repair or replace any part of the appliance or attempt any servicing. Note: If for any reason this product requires service, we strongly recommend that a certiﬁed technician perform the service.

11. When cutting or drilling into wall or ceiling, be careful not to damage existing electrcal wiring and other hidden utilities.

12. Ducted fans must always be vented to the outdoors.

WARNING – TO REDUCE THE RISK OF RANGE TOP GREASE FIRES:

1. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

2. Always turn the hood ON when cooking at high heat or when ﬂambeing foods (i.e. Crepes, Suzette, Cherries Jubilee. Peppercorn Beef Flambe).

English

3. Use proper-sized pans that correspond to the size of the stove, and the amount of food

being cooked.

4. Clean ventilation fans frequently. Do not allow grease to accumulate on the fan

or the ﬁlter.

WARNING – TO REDUCE THE RISK TO PERSONS IN THE EVENT OF A RANGE TOP GREASE

FIRE, OBSERVE THE FOLLOWING:

1. SMOTHER FLAMES with a close-ﬁtting lid, cookie sheet, or metal tray. Then turn off the

burner. BE CAREFUL TO AVOID BURNS. If the ﬂames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. (911).

2. NEVER PICK UP A FLAMING PAN. You may be injured.

3. DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosion will result.

4. Use an extinguisher only if:

a) You know you have a Class ABC extinguisher, and you already know how to use it.

b) The ﬁre is small and contained in the area where it started.

CAUTION! Important – Observe all governing codes and ordinances.

1. For general ventilation use only. Do not use this appliance to exhaust hazardous

or explosive materials and vapors.

2. To reduce the risk of ﬁre, use only metal ductwork.

3. To avoid damage to motor or other components, keep drywall spray, construction dust,

etc. off the power unit.

4. Please read speciﬁcation label on product for further information and requirements.

SAVE THESE INSTRUCTIONS

Thank you for using our Haier product. This easy-to-use manual will guide you in getting the best performance from your Haier Range Hood.

Remember to record the model and serial number from the label on the unit.

Staple your receipt to your manual.

You will need it to obtain warranty service.

Model number

Serial number

Date of purchase

English

Table Of Contents

PAGE

Safety Precautions..................................................................................................1-2

Accessories.......................................................................................................3

Important Safeguards................................................................................................4

Installation Preparation..............................................................................................5

Cabinet Preparation for Hoods Support........................................................................6

Vertical Discharge.....................................................................................................6

Ductless......................................................................................................6

Preparing Electrical Connections.................................................................................6

Wiring Diagrams......................................................................................................7

Installing Ductwork....................................................................................................7

Hood Installation....................................................................................................7-8

Use and Care...........................................................................................................9

Troubleshooting.........................................................................................10

Limited Warranty.....................................................................................................11

Accessories

Range Hood Accessories Provided:

1 Range Hood 1 Damper Flap 4 Damper Screws 4 Range Hood Screws 4 Washers 2 Wire Connectors 2 Aluminum Filter 2 Charcoal Inserts 1 User Manual 1 Warranty Card

Check to make sure that all parts and accessories are present and in good condition. If you ﬁnd that they are not in good condition or are missing, please contact our customer service department for assistance.

Our Toll-Free number is 1-877-337-3639.

English

Important Safeguards

WARNING Disconnect the range hood from power supply before servicing.

WARNING To reduce the risk of ﬁre or electric shock or injury to persons observe

the following:

a) Use this unit only in the manner intended by the manufacture. If you have questions, contact the manufacture.

b) Before servicing or cleaning the unit, switch power to off at service panel and lock the service panel to prevent power from being switched on accidentally. When the service panel cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

c) Installation work and electrical wiring must be done by qualiﬁed person(s) in accordance with all applicable codes and standards, including ﬁre-rated construction.

d) Sufﬁcient air is needed to prevent combustion and exhausting of gases through the ﬂue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacture’s guide and safety standards, such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

e) When cutting or drilling into wall or ceiling, do not damage electrical wiring or other hidden utilities.

CAUTION For general ventilating use only. Do not use to exhaust hazardous or explosive

materials or vapors.

CAUTION To reduce the risk of ﬁre, use only metal ductwork.

CAUTION To reduce the risk of ﬁre and to properly exhaust air, be sure to duct air outside.

Do not vent exhaust air into spaces within walls or ceilings, or into attics, crawlspaces, or garages.

WARNING To reduce the risk of a range top grease ﬁre:

a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

b) Always turn the hood ON when cooking at high heat or when cooking ﬂaming foods.

c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or ﬁlter.

d) Always use proper pan size. Always use cookware appropriate for the size of the surface element.

English

Installation Preparation

To install this range hood, you will need the following tools and materials:

Note: This procedure will require 2 people for easier installation.

Tools Needed for Installation

• Drill

• 1/8" Drill bit for drilling pilot holes

• 1-1/4" Wood bit for drilling electrical wiring access hole

• 3/8" Nut Driver or Ratchet with Extension

• Phillips head screwdriver

• Flat-head screwdriver

• Pliers

• Pencil, ruler and level for marking range hood location

• Hand saw or jig saw for cutting the wall or cabinet openings

• Duct tape

• Electrical tape

• Connector Clamp

General Preparation Caution! Please be sure to turn the electrical power switch OFF before beginning

the installation.

1. Remove the range hood from the carton.

2. Lay the range hood upside down on a table covered with either cardboard or paper to prevent scratching the hood or table.

3. Remove the 2 grease ﬁlters from the hood. Place them somewhere safe so they will not be damaged.

4. Install two 40 Watt light bulbs.

5. Turn the hood right side up so you can see the duct knockouts and mounting holes.

English

Cabinet Preparation for Hood Support

Mount the hood so that the bottom of the hood is between 24"-30" above the stovetop. Warning! When cutting or drilling into wall or cabinet, be careful not to cut

existing electrical wiring.

1. If the bottom of the cabinet is recessed above the bottom of the cabinet door, then it

is necessary to install wood strips on each side of the recessed area on the bottom of the cabinet where the range hood will be mounted. The wood strips should line up with the 4 keyhole slots on the top of the range hood. Fasten the wood strips with wood screws about 3" in from each end. Note: The thickness of the wood strips should be slightly more than the recessed

dimension. The length should be cut to size.

2. Measure and mark the electrical wiring opening in the wall or the cabinet. If the hood is

to be vented, also mark and measure the duct opening in the wall or cabinet.

Vertical Discharge – Vertical discharge is the only method of hood installation. If your kitchen has an attic space above, the ducting may be run through the cabinet and the attic to a roof cap. Another option, if your kitchen has a sofﬁt above the cabinet, is to run the duct up into the sofﬁt and then discharge the air horizontally through the outside wall to a wall cap.

Ductless – In ductless installations, air is vented back into the kitchen through the opening in the range hood grille. If you do not anticipate heavy cooking, this method may be preferable. Ductless installation requires the use of a charcoal ﬁlters (included) to remove odors, which should be replaced at regular intervals depending on use. Check with your local retailer or dealer for replacements.

Note: This charcoal ﬁlter is not dishwasher safe!

Preparation of Electrical Connections Note: If replacing an existing hood, the electrical cable may need to be re-routed to

the desired position.

1. Determine the location of the electrical cable to connect to the range hood. The

preferred location for the electrical connector, vertical or horizontal, will depend on the existing installation or ease of routing wiring. All electrical connections must comply with national and local codes. Transfer the location of the selected range hood knockouts to the bottom of the cabinet or onto the wall, then cut or drill a hole to allow for clearance of the electrical cable clamp. Be careful not to cut into any hidden utilities, such as electrical wires.

5. Attach the ducting to the hood.

6. Temporarily mount the stainless steel chimmey and mark the top.

English

7. Attach the mounting clamp to the wall with supplied screws.

8. Connect the chimmey to the mounting clamp.

English

Use and Care

Aluminum Filter

For highest efﬁciency, this ﬁlter should be removed and cleaned periodically. Soak the ﬁlter in hot water and mild soap or detergent. Rinse thoroughly and repeat if necessary. The aluminum ﬁlter may be cleaned in the dishwasher. Heavy grease buildup may not be cleaned easily, thus the ﬁlter may need to be replaced.

Charcoal Filter

Inspect this ﬁlter periodically. This ﬁlter cannot be cleaned and must be replaced when it becomes saturated. Check with your local retailer or dealer to purchase.

Light Bulb

Use only Halogen MR-16 type bulbs. (Not shipped with range hood.)

Exterior Surface

Wipe the range hood exterior with a soft cloth and a mild detergent suitable for painted surfaces. Do NOT use abrasive materials such as steel wool pads or scouring powders.

Repair or Replacement Parts WARNING! Disconnect range hood from the electrical power supply before servicing.

All parts may be obtained from service centers authorized by Haier, or may be ordered directly from Haier. When ordering parts, please specify the range hood model number on the rating label, which is located on the inside of the range hood.

English

Troubleshooting

Fan does not turn on (but light turns on).

This is probably due to either a defective fan switch or a burned-out fan motor. Both can be replaced without removing the range hood from the wall or cabinet. Use an ohm meter to determine which component is not working. If the ohm meter reads that the fan switch has 0 ohms of resistance, then it is the motor that needs to be replaced. If it reads anything other than zero, then the switch must be replaced.

Fan only runs at one speed.

Please see instructions above for troubleshooting when your fan does not turn on (but light turns on).

Fan circulates air, but does not vent outside.

If air is blowing through the front vent openings, then your range hood has been installed for ductless operation. In order to convert the system to vent outside, a technician must install metal ductwork from the range hood through either an outside wall or the roof.

If air is not blowing from the front vent openings, check inside the cabinet above the range hood. If you see a metal duct leading away from the vent hood, then you have a system that vents to the outdoors. If you do not see a duct, your unit may be venting through the back wall.

Light does not turn on (but fan turns on).

This could be because the bulb has burned out. Try replacing the light bulb. If the light still does not work, either the light switch or the lamp-holder socket is defective. Both can be replaced without removing the range hood from the wall or cabinet.

Night light does not turn on.

Please see above instructions for troubleshooting when the light that does not turn on (but fan turns on).

Range hood does not turn on at all.

Check for a tripped circuit breaker or a blown fuse, since the range hood is wired directly to your household electrical system.

NOTE: All work must be performed by a qualiﬁed and licensed technician!

+ 23 hidden pages