INSTALLATION INSTRUCTIONS USER GUIDE
Standard Rangehood
HFH60RSX1
NZ AU
Cod:0103086668-00.01
CONTENTS
|
|
Safety and warnings |
3 |
Installation instructions |
5 |
Operating instructions |
13 |
Cleaning and maintenance |
14 |
Parts and accessories |
16 |
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this user guide may not be available in all markets and are subject
to change at any time. For current details about model and specification availability in your country, please go to our local website listed on the back cover or contact your local Haier dealer.
Registration
Register your product with us so we can provide you with the best service possible.
To register your product visit our website: https://www.haier.co.nz/ or https://www.haier.com.au.
1
SAFETY AND WARNINGS
! WARNING!
Net Weight
5.5 kg
Gross Weight
6.5 kg
Weight Hazard
The rangehood is heavy. Please ensure adequate care is taken when installing the rangehood to prevent personal injury. The rangehood must be installed onto a solid wall, stud, beam or truss.
Weight of the HFH60 is net weight 5.5 kg, gross weight 6.5 kg.
!WARNING!
Electric Shock Hazard
Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs. Alterations to the domestic wiring system must be made by a qualified electrician.
Failure to follow this advice may result in electric shock or death.
IMPORTANT SAFETY INSTRUCTIONS
WARNING! When using this appliance always exercise basic safety precautions including the following:
Please read the entire set of instructions before installing or using this appliance. Please make this information available to the person installing the appliance – doing so could reduce your installation costs.
Always switch the power off prior to installation, servicing or cleaning
This appliance must be installed and connected to the mains power supply only by a suitably qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations. Failure to install the
To comply with electrical safety regulations, the rangehood must be plugged into
isolating switch, to enable the end user to isolate the rangehood from the power for
A power outlet should be within 750 mm of the motor assembly and can either be on
If the supply cord of this equipment is damaged, it must only be replaced by the
Ducting accessories are not supplied. All ducting must comply with local requirements and building codes.
Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled.
Before connecting any pipes, consult municipal ordinances to ensure that any applicable regulations concerning the discharge of exhaust air are adhered to and request permission from the person in charge of the building.
Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from appliances burning gas or other fuels.
3
SAFETY AND WARNINGS
4
Loading...