Domestic Dishwasher
DW12-AFM4
DW12-AFM4ME
GB |
Code: 0120504930 |
Safety Is Very Important
IMPORTANT
Carefully read the instructions contained in this manual, as it provides information that is essential to safe and proper installation, use and maintenance of this appliance.
This appliance complies with following EEC
directives:
-73/23/EEC of 19/02/73(Low Voltage)and subsequent modifications;
-89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications.
-Carefully dispose of the packing material.
-After removing the packing, check to make sure that the appliance is not damaged. If in doubt, contact a qualified professional.
-The dishwasher must only be used by adults for the washing of household dishes and cooking utensils.
-Fundamental rules to follow when using the appliance:
*Never touch the dishwasher with wet hands;
*We discourage the use of extension cords and multiple sockets;
*During installation, the power supply cord must not be excessively or dangerously bent or flattened;
*If the appliance is not operating properly or, requires maintenance, disconnect the appliance from the power supply.
-Keep detergents out of the reach of children. Also keep children away from the dishwasher when it is open to reduce the risk of injury.
-This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof. It is also very dangerous to leave it exposed to the rain and elements.
-Do not touch the heating element during or after a wash cycle.
-Do not lean or sit on the door when it is open, as this could overturn the dishwasher.
-If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, refer to the "Troubleshooting section on page 9." If you cannot resolve the problem, contact an authorised service agent.
-Only specialised personnel are authorised to make repairs.
-Appliances which are being discarded must be made inoperable by cutting the power supply cord and removing the
door lock.
-The appliance must be positioned so that the plug is accessible.
-If installing this dishwasher on a carpeted floor, ensure the car pet does not obstruct the opening.
-If the supply cord is damaged, it must be replaced by the manufacture, its service agent of similarly qualified persons in order to avoid a hazard.
Close-up View (Control Panel)
A B C D
I H |
G |
F |
|
E |
|
A |
ON-OFF Light |
|
F |
Handle For Opening Door |
|
B |
ON-OFF Button |
|
G |
"Eco" Button |
|
C |
Low Salt Indicator Light |
|
H |
"HALF LOAD" Button |
|
D |
Low Rinse Aid Indicator Light |
I |
"Pots & Pans" Button |
||
E |
Knob For Selecting Cycle |
|
|
|
|
|
|
|
.1. |
|
GB |
|
|
|
|
|
|
Close-up View (Interior)
A
B
C
D
Upper Rack |
E |
Bottom Spray Arm |
Rack Height Adjustor |
F |
Washing Filter |
Top Spray Arm |
G |
Detergent and Rinse Aid Dispenser |
Lower Rack |
H |
Salt Container Cap |
|
I |
Third Sprayer |
Technical Characteristics
Width |
60 cm |
|
|
Depth |
60 cm |
|
|
Height |
85 cm |
|
|
Capacity |
12 standard place settings |
|
|
Mains water pressure |
0.03-0.6 MPa |
|
|
Power voltage |
220-240V~ 50Hz |
|
|
Total absorber power |
2100W |
|
|
GB |
.2. |
|
S a l t
Salt
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
-Remove the lower rack and then unscrew and remove the cap from the salt container;
-If you are filling the container for the first time, fill it with water;
-Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container.
-Carefully screw the cap back on.
The salt container must be filled when the "low salt" indicator light appears on the control panel.
To prevent the formation of rust, load the salt just before beginning a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimise and customise the level of salt consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
-Unscrew the cap from the salt container;
-There is a ring on the container with an arrow on it (see figure to the side).
-If necessary, rotate the ring in the anticlockwise direction from the "-" setting towards the "+" sign, based on the hardness of
the water being used.
It is recommended that adjustments be made in accordance with the following scheme:
Water Hardness |
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
Selector |
Salt |
Autonomy |
Clarke |
dH |
|
|
c o n s u m p t i o n |
||
|
mmol/l |
(cycles/2kg) |
||||
degrees |
|
position |
||||
|
|
|
(Grams/cycle) |
|
||
|
|
|
|
|
|
|
0 14 |
M NT |
|
M NIT |
L |
M |
L |
|
|
|
|
|
|
|
NQ PS |
NU QQ |
|
NIU QIQ |
=?J? |
OM |
SM |
|
|
|
|
|
|
|
PS TN |
QR UV |
|
QIR UIV |
jba |
QM |
QM |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
[TN |
[UV |
|
[UIV |
?H? |
SM |
OR |
|
|
|
|
|
|
|
.3. |
GB |
Loading...